AVSPARE.COM
parts catalog

PLUG 0005618 - Caterpillar



0005618 PLUG Caterpillar parts PLUG
Rating:
76
Alternative (cross code) number:
CA0005618
000-5618
0005618
Caterpillar 0005618 PLUG
Weight: 0.02 pounds 0 kg.

Buy PLUG 0005618 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision components of the pump. All assembly procedures must be performed on a clean work surface and in a clean hydraulic area. Keep cleaned parts covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g00835474
Illustration 2 g00835513
Use Tooling (A) and Tooling (B) in order to lift pumps (32) through the access hole in the bottom of the machine. The weight of the pumps is approximately 77 kg (170 lb). Position the two pumps and install bolts (31). Tighten bolts (31) to a torque of 270 40 N m (199 30 lb ft).
Illustration 3 g00835466
The above view is from the underside of the machine.
Connect hose assemblies (30), (29), and (28). Connect hose assemblies (27), (26), and (25).
Illustration 4 g00835464
Connect hose assemblies (24) and (23).
Illustration 5 g00835461
Connect hose assemblies (22) and (21). Connect hose assembly (20) for the test port.
Illustration 6 g00835422
Connect hose assembly (18). Install hoses (19) and (17). Connect hose assembly (16).
Illustration 7 g00835409
Install hose assemblies (15) and (14). Install tube assembly (13). Install hose assemblies (12) and (11).
Illustration 8 g00835377
Connect harness assemblies (10) and (9).
Illustration 9 g00835355
Connect harness assemblies (8) and (7).
Illustration 10 g00835331
Install air ducting (6) and bolts (5).
Illustration 11 g00835329
Install floor access plate (4) in the machine.
Illustration 12 g00835327
Install floormat (3) and footrests (2).
Illustration 13 g00835558
Use Tooling (B) to position middle bottom guard (1) for installation. The weight of the middle bottom guard is approximately 35 kg (77 lb). Install the bolts for the middle bottom guard.
Fill the hydraulic tank. Refer to Operation and maintenance Manual, "Hydraulic System Oil - Change" and Operation and maintenance Manual, "Capacities (Refill)". End By:
If equipped, install the piston pump for the winch and the brace that supports the winch. Refer to Disassembly and Assembly, RENR5543, "Piston Pump (Hydrostatic) - Install".


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.