AVSPARE.COM
parts catalog

Plug 70000010 - Caterpillar



70000010 Plug Caterpillar parts CB-414 Plug
Rating:
8
Alternative (cross code) number:
CA70000010
7000-0010
70000010
Caterpillar 70000010 Plug

Buy Plug 70000010 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: 70000010:

VIBRATORY COMPACTOR  CB-414   Caterpillar
Number on catalog scheme: 17
 
  For full view, you need register

Information:

Which Generate This Code:This diagnostic code is recorded when the all wheel drive ECM does not receive expected information from the transmission ECM for a period of more than five seconds.System Response:This failure results in events that are logged against an ECM that can not be explained directly. The all wheel drive ECM cannot communicate with this ECM or the ECM appears to communicate intermittently. Prior to performing this procedure, check for an active diagnostic code of CID 0248 FMI 09. If this diagnostic code is present exit this procedure and perform the diagnostic procedure for CID 0248 FMI 09.Test Step 1. VERIFY THE HARDWARE AND THE SOFTWARE PART NUMBERS.
Verify that the following information is correct:
The part number of the transmission's flash software
The part number of the transmission ECM
The part number of the all wheel drive's flash software
The part number of the all wheel drive ECMNote: Consult the Business Unit that produces the product for the correct part numbers of the flash software.Expected Result:All the part numbers are correct.Results:
OK - All the part numbers are correct. Proceed to Test Step 2.
NOT OK - All the part numbers are NOT correct. Repair: The installed ECM has the wrong part number or the incorrect software is installed. Replace the incorrect ECM with a module that has the correct part number. Flash the correct software. See the Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program" section of this manual. Stop.Test Step 2. CHECK FOR OTHER CODES.
Check for similar diagnostic codes that are logged against other electronic control modules. If a similar diagnostic code is found, exit this test and perform the corresponding procedure(s) for the other diagnostic codes that are shown.Expected Result:Other diagnostic codes are showing.Results:
YES - Exit this procedure and perform the diagnostic procedure for the diagnostic codes that are shown. Stop.
NO - There are no other related diagnostic codes. Proceed to test step 3. Test Step 3. INSPECT THE HARNESS CONNECTORS.
Turn the key start switch and the disconnect switch to the OFF position.
Inspect the connections of the machine harness that are related to the CAT data link.
Make sure that connectors are clean and tight.Expected Result:The machine harness is correct.Results:
OK - The machine harness is correct. Proceed to test step 4.
NOT OK - The machine harness is not correct. Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 4. CHECK FOR A SHORT TO GROUND.
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness from all electronic control modules that use the CAT data link.
At the machine harness connector for the ECM, measure the resistance between frame ground and the CAT data link circuits (contacts J1-3 and J1-9).Expected Result:The resistance measurement should be greater than 5000 ohms.Results:
YES -

Caterpillar parts catalog:

Caterpillar parts catalog
CP-323 VIBRATORY COMPACTOR 6JD00001-00065 (MACHINE) POWERED BY 4219D ENGINE
CB-414 VIBRATORY COMPACTOR 6KD00001-UP (MACHINE) POWERED BY 4239D ENGINE


Parts plug Caterpillar catalog:

1206250 PLUG
CB-414, CB-514, CB-614
56000261 PLUG
CB-414, CB-514, CS-431
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.