AVSPARE.COM
parts catalog

PULLEY GP-CRANKSHAFT 1247309 - Caterpillar



1247309 PULLEY GP-CRANKSHAFT Caterpillar parts 3176C, 3196, C-12, C12 PULLEY
Rating:
37
Alternative (cross code) number:
CA1247309
124-7309
1247309
Caterpillar 1247309 PULLEY GP-CRANKSHAFT

Buy PULLEY GP-CRANKSHAFT 1247309 Caterpillar genuine, new aftermarket tractor parts with delivery
MARINE ENGINE,

Compatible equipment models: 1247309:

MARINE ENGINE  3176C   3196   C-12   C12   Caterpillar
Number on catalog scheme:
 
  For full view, you need register

Information:


Personal injury or death can result from machine articulation or movement.Machine frames can move and a person can be crushed.Connect the steering frame lock link between the front and rear frames before working on machine.
Note: Perform the check for the lift cylinder drift and the tilt cylinder drift with an empty general purpose bucket.
Move the machine to a smooth, horizontal location. Move the machine away from other operating machines and away from personnel.
Move the direction control switch to the NEUTRAL position.
Lower the bucket to the ground. Stop the engine.
Engage the parking brake.
Place chocks in front of the wheels and behind the wheels.
Connect the steering frame lock.
Fasten the seat belt. Start the engine and warm the hydraulic oil to 55° 10°C (130° 18°F).
Run the engine at high idle.
Operate the lift cylinder through five cycles. This will ensure that there is warm oil in the lift cylinder.
Operate the tilt cylinder through five cycles. This will ensure that there is warm oil in the tilt cylinder.
Raise the bucket to the full RAISE position.
Tilt the bucket until the bucket is parallel with the ground.
Reduce the engine speed to low idle. Stop the engine.
Measure the amount of rod movement in five minutes. The maximum rod movement in the lift cylinder and the tilt cylinder should not exceed 15 mm (0.6 inch).Note: If the lift cylinder drift and/or the tilt cylinder drift exceeds the maximum, refer to Testing and Adjusting, "Hydraulic System Troubleshooting" for probable causes.
Fasten the seat belt and start the engine.
Lower the bucket to the ground.
Remove the chocks.
Disconnect the steering frame lock.

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts pulley Caterpillar catalog:

2977747 PULLEY GP-ENGINE
320D, 320D GC, 320D L, 320D LRR, 320D RR, 321D LCR, 323D L
6I1379 PULLEY GP-FAN DRIVE
517, D4H, D4H XL, D4HTSK III
2177832 PULLEY GP-WATER PUMP
216, 216B, 232B, 242B, 3013C, 3024C, C1.5, C2.2, CB-334E
3244558 PULLEY GP-ENGINE
324E L, 324E LN, 329E, 329E L, 329E LN
2131651 PULLEY GP-FAN
3126B, 3126E, C7, C9
2P8601 PULLEY GP-BELT
814, 815, 816, 966C, 977L, D5, D6C
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.