AVSPARE.COM
parts catalog

PUMP GP 3599505 - Caterpillar



3599505 PUMP GP Caterpillar parts PUMP
Rating:
61
Alternative (cross code) number:
CA3599505
359-9505
3599505
Caterpillar 3599505 PUMP GP
Weight: 1 pounds 0 kg.

Buy PUMP GP 3599505 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

1. Remove the control valve, oil manifold, oil cooler and oil pump. If the marine gear is attached to the engine, proceed with Step 2. If the marine gear is separated from the engine, rotate the clutch to locate the clutch lifting eye hole at the top. Block between the marine gear lower housing and the clutch drive teeth before removing the upper housing.
BLOCKING THE CLUTCH2. Loosen the bolts in the upper halves of the bearing rear retainers. Do not loosen the bolts in the front retainers.
BEARING RETAINERS ON BEARING CAP SADDLES3. Remove the bolts securing the two halves of the marine gear together and install a hoist to lift the upper housing. Remove the upper housing.4. Remove the bearing cap saddles.5. If the marine gear is attached to the engine, remove the bolts securing the clutch drive ring to the engine flywheel by rotating the flywheel to position the bolts upward for removal. When all drive ring bolts are removed, loosen the bolts in the bearing retainers in the lower housing.6. Install a lifting eye into the clutch and secure the clutch to the ahead drive gear with two FT840 Brackets. The brackets prevent the driving portion of the clutch from separating from the drive shaft assemblies during storage or service work.7. If the marine gear is attached to the engine, remove the bolts securing the clutch drive ring to the engine flywheel and slip the drive rings rearward onto the clutch.8. Loosen the bolts in the bearing rear retainers (1) in the lower housing. Do not loosen the bolts in the front retainers (2).9. Install a hoist to the clutch lifting eye and attach a strap to the ahead drive gear to allow the shaft to be horizontal as it is removed from the housing.
FT840 BRACKET AND LIFTING EYE INSTALLED
1-Bearing rear retainers. 2-Bearing front retainers.


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.