AVSPARE.COM
parts catalog

RADIATOR GP 3599589 - Caterpillar



3599589 RADIATOR GP Caterpillar parts RADIATOR
Rating:
76
Alternative (cross code) number:
CA3599589
359-9589
3599589
Caterpillar 3599589 RADIATOR GP
Weight: 496 pounds 224 kg.

Buy RADIATOR GP 3599589 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Start By:a. remove camshaft 1. Remove four bolts (1), thrust plate (2), and idler gear (3). 2. Use tooling (A) and a press to remove the bearing from idler gear (3). 3. Remove thrust washer (4), bolts (5), and shaft (6) from the cylinder block. 4. Use tooling (B) to remove gear (7) from the crankshaft.Install Timing Gears
1. Turn the crankshaft so dowel (2) in the crankshaft is up, as shown.2. Heat crankshaft gear (1) to a maximum temperature of 233°C (451°F). Install crankshaft gear (1) on the crankshaft. Make sure the side of the gear with "V" timing mark (3) is out, as shown. Make sure the groove (slot) in the crankshaft gear is in alignment with dowel (2) on the crankshaft. Make sure the crankshaft gear aligns with the idler gear for the oil pump. 3. Install shaft (4) and bolts (5). Put clean engine oil on thrust washer (6). Install thrust washer (6) on the shaft so that oil groove (7) is out, as shown. 4. Use tooling (A) and a press to install the bearing in the idler gear. Install the bearing so that the bearing joint is in the thick area of the gear. This is the area that is the opposite of surface (9). Install the bearing so that it is 0.38 0.25 mm (.015 .010 in) below the surface on the opposite side of the gear surface (8).5. Put clean engine oil on the bore of bearing. 6. Install idler gear (10) on the shaft. Make sure "V" mark (11) on the idler gear aligns with the "V" mark on the crankshaft gear. Install thrust plate (12) so that the side of the thrust plate with the oil groove (13) is toward the idler gear.7. Put clean engine oil on the side of the thrust plate that is next to the idler gear. Install the thrust plate (12) and the four bolts that hold this plate in place.End By:a. install camshaft


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.