AVSPARE.COM
parts catalog

RING-RETAINING 1C3950 - Caterpillar



1C3950 RING-RETAINING Caterpillar parts PR-450 RING
Rating:
16
Alternative (cross code) number:
CA1C3950
1C-3950
1C3950
Caterpillar 1C3950 RING-RETAINING
Weight: 0.09 pounds 0 kg.

Buy RING-RETAINING 1C3950 Caterpillar genuine, new aftermarket tractor parts with delivery
COLD PLANER,

Compatible equipment models: 1C3950:

COLD PLANER  PR-450   Caterpillar
Number on catalog scheme: 9
 
  For full view, you need register

Information:

System Operation Description:Every generated code is stored in the memory of the module that detected the problem. The codes remain in the memory of the module even if power is removed from the module.The diagnostic reset switch allows the operator to clear the diagnostic codes. Diagnostic codes cannot be individually cleared. Toggling the switch clears all of the diagnostic codes in all of the modules.Note: Do not clear the diagnostic codes until all of the codes have been addressed.If the engine is not equipped with the optional air/fuel ratio control, the EIS control module clears the codes. The codes are cleared when terminal "h" of the EIS connector is connected to ground.If the input for clearing the codes is connected to ground for more than ten seconds, a 321-04 diagnostic code will be activated.
Illustration 1 g01171944
Schematic diagram of the diagnostic reset switchThe engine is equipped with a 70 pin connector and a EMCP II.
Illustration 2 g01164628
Schematic diagram of the diagnostic reset switchThe engine is equipped with a remote control panel.
Illustration 3 g01171759
Schematic of the diagnostic reset switchThe engine is equipped with a 70 pin connector.
Illustration 4 g01164631
Schematic diagram of the diagnostic reset switchThe engine is not equipped with a remote control panel.Test Step 1. Inspect the Electrical Components and the Wiring
Set the engine control to the OFF/RESET mode. Remove the electrical power from the engine.Note: For the following steps, refer to Troubleshooting, "Inspecting Electrical Connectors".
Thoroughly inspect each of the following components:
EIS connectors
The appropriate terminals on the terminal strips
The electrical connections for the diagnostic reset switch
The electrical connections for the idle/rated switch
The electrical connections for the oxygen calibration switch
Illustration 5 g01044800
Harness side of the EIS connector (EISC-B) −Battery (EISC-h) Diagnostic reset
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the circuit for the diagnostic reset.
Check the wiring for corrosion, for abrasion, and for pinch points.Expected Result:The components and the wiring are connected properly. The connectors and the wiring do not have corrosion, abrasion, or pinch points.Results:
OK - The components are in good condition with proper connections. If you are troubleshooting a 321-04 diagnostic code, proceed to Test Step 2. If toggling the switch does not clear the codes, proceed to Test Step 3.
Not OK - The components are not in good condition and/or at least one connection is improper.Repair: Perform the necessary repairs and/or replace parts, if necessary.STOPTest Step 2. Check for a Short Circuit
Disconnect the EIS connector.
Measure the resistance between the points that are listed in Table 1.
Table 1
Resistance Measurements for the Harness for the Diagnostic Reset Switch    
Terminals on the EIS Connector    
EISC-h (Input for the diagnostic reset)     EISC-B (−Battery)    
EISC-L (Shutdown switch)
EISC-Y (Ground for the left detonation sensor)
EISC-Z (Ground for the speed/timing sensor)
EISC-c (Return for the ignition transformer for cylinder 13)
EISC-d (Ground for the right detonation sensor)
EISC-n (Return for the ignition transformer for cylinder 1)
EISC-p (Return for the ignition transformer for cylinder 3)
Shell for the EIS connector Expected Result:

Caterpillar parts catalog:

Caterpillar parts catalog
PR-450 COLD PLANER 7DC00204-UP (MACHINE) POWERED BY 3408 ENGINE


Parts ring Caterpillar catalog:

1L3768 RING
129, 130G, 143H, 163H, 236, 236B, 267, 287, 315D L, 316E L, 318D2 L, 318E L, 330D L, 336D, 416B, 416C, 416D, 416E, 416F, 420D, 420E, 420F, 422E, 424D, 426B, 426C, 428, 428B, 428C, 428D, 428E, 430D, 43...
8F4610 RING-RETAINING
12G, 12H, 12H ES, 12H NA, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H NA, 160H, 160H ES, 160H NA, 163H NA, 16G, 16H NA, 235B, 245, 3116, 3126, 3126B, 3176, 3176B, 3176C, 3196, 3208, 330, 330 FM L, 33...
8S7803 RING-RETAINING
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 135H NA, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD,...
9M7611 RING-RETAINING
1140, 1150, 1160, 120G, 130G, 140G, 1673B, 1673C, 1676, 16G, 215, 225, 235, 245, 3204, 3208, 330 L, 3304, 3306, 3306B, 3406, 3406B, 3408, 3408B, 3412, 3508, 3508B, 3512, 3516, 5130, 528, 572G, 578, 58...
6J5731 RING-BACKUP
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M 2, 14...
8L9811 RING-RETAINING
120G, 12G, 130G, 140G, 160G, 3176, 3176B, 3304, 3408, 3408C, 3408E, 3412, 3412C, 3412D, 3412E, 561H, 561M, 561N, 572R, 572R II, 651E, 657E, 69D, 75, 75C, 768C, 769C, 769D, 770, 771C, 771D, 772, 772G, ...
0688093 RING-RETAINING
30/30, 572R, 572R II, 578, 583R, 583T, 587R, 587T, 611, 615, 615C, 814B, 814F, 814F II, 815B, 815F, 815F II, 816F, 816F II, 950B, 950B/950E, 966D, 966F, 966F II, 966G, 966G II, 970F, 972G, 972G II, 97...
6L6560 RING-RETAINING
589, D10N, D10R, D10T, D10T2, D8L, D9L, D9N, D9R, PR-105, PR-450, PR-450C
3237479 RING-BACKUP
320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 568 FM LL
2970608 RING-BACKUP
320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 336E, 336E L, 336E LN, 336F L, 345D, 345D L, 568 FM LL
2478730 RING-RETAINING
336E, 336E HVG, 336E L, 336E LN, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L HVG, 349E L VG, 349F L, 568 FM LL, W345C MH
2478787 RING-RETAINING
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E HVG, 336E L, 336E LN, 340D L, 340D2 L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 34...
7I8171 RING-BACKUP
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E HVG, 336E L, 336E LN, 340D L, 340D2 L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 34...
7I8172 RING-BACKUP
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E HVG, 336E L, 336E LN, 340D L, 340D2 L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 34...
0817048 RING
AP-1200, AP-800
8C7690 RING
AP-1200, AP-800
8C0920 RING
PR-105, PR-450
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.