AVSPARE.COM
parts catalog

Ring, snap 70000035 - Caterpillar



70000035 Ring, snap Caterpillar parts CB-414, TSF-54, TSM-54 Ring
Rating:
16
Alternative (cross code) number:
CA70000035
7000-0035
70000035
Caterpillar 70000035 Ring, snap

Buy Ring, snap 70000035 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: 70000035:

VIBRATORY COMPACTOR  CB-414   TSF-54   TSM-54   Caterpillar
Number on catalog scheme: 1
 
  For full view, you need register

Information:


Illustration 1 g00801447
Schematic of the solenoid valve (charge)This diagnostic code is associated with the solenoid valve (charge). The FMI 05 means that the ECM has determined that the current of the solenoid is below normal. The possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0392 FMI 05 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code of CID 0392 FMI 05 will be logged in the internal memory of the All Wheel Drive ECM.The AWD feature will be disabled.Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Disconnect the solenoid with the active diagnostic code from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 2 (wire 989-YL) to contact 1 (wire 912-GY).
Observe the status of the CID 0392 FMI 05.Expected Result:The CID 0392 FMI 05 remains active. The FMI has not changed and the "05" is still active.Results:
YES - The diagnostic code remains active. The jumper wire does not affect the diagnostic code. Proceed to Test Step 2.
NO - The diagnostic is no longer active. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem. Stop.Test Step 2. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector(s) from the ECM.
The jumper wire that was installed in the previous Test Step remains in place.
At the machine harness connector, measure the resistance from signal contact J1-12 (wire 989-YL) to contact J1-7 (wire 912-GY).Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire 989-YL or in wire 912-GY of the machine harness. Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0392 FMI 05.Expected Result:The CID 0392 FMI 05 is active. Results:
YES - The CID 0392 FMI 05 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM

Caterpillar parts catalog:

Caterpillar parts catalog
CP-323 VIBRATORY COMPACTOR 6JD00001-00065 (MACHINE) POWERED BY 4219D ENGINE
CB-414 VIBRATORY COMPACTOR 6KD00001-UP (MACHINE) POWERED BY 4239D ENGINE
TSM-54 VIBRATORY COMPACTOR 7LD00001-UP (MACHINE) POWERED BY F2L-511D ENGINE
TSF-54 VIBRATORY COMPACTOR 7KD00001-UP (MACHINE) POWERED BY F2L-511D ENGINE


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.