77050005 Ring, drive Caterpillar parts Ring
Rating:
Alternative (cross code) number:
CA77050005
7705-0005
77050005
CA77050005
7705-0005
77050005
Information:
A machine may shift if improper procedures or equipment are used for lifting and tying down for transport. Ensure that proper equipment and procedures are used for lifting and tying machines down for transport. If a machine shifts it could cause personal injury or death.
Illustration 1 g00912199
Improper lifting or tiedowns can allow load to shift and can cause injury and damage.
Note: The machine shipping weight that is listed is the weight of the most common configuration of the machine. If attachments have been installed on your machine, the weight of your machine and the center of gravity of your machine may vary.See Operations and Maintenance Manual, "Specifications" for the weight of the machine.
Lifting Point - In order to lift the machine, attach the lifting devices to the lifting points.
Tie Down Point - In order to tie down the machine, attach the tie-downs to the tie down points. Use properly rated cables and properly rated slings to lift the machine. Position the crane or the lifting device in order to lift the machine in a level position.The width of the spreader bar must be sufficient to prevent the lifting cables or the lifting straps from contacting the machine.
Engage the parking brake before you attach a lifting device to the machine and before you secure the machine with tie-downs.
Install the frame lock pin prior to lifting the machine.
Attach two lifting cables to the rear of the machine. There is one lifting eye on each side of the rear of the machine. The lifting eyes are identified by a label that shows a hook.
Attach two lifting cables to the front of the machine. There is one eye on each side of the front of the machine. The lifting eyes are identified by a label that shows a hook.
Connect the four lifting cables to the spreader bars. The spreader bars must be centered over the machine.
If equipped, secure any attachments.
Lift the machine. Move the machine to the desired position.
When the machine is positioned, place the blocks behind the tires.
Secure the machine at the tie-down positions. The positions are identified on the machine by a label.Check all of the laws that govern the load characteristics (height, weight, width, and length).Refer to Operation and Maintenance Manual, "Shipping the Machine" for shipping instructions for your machine.