AVSPARE.COM
parts catalog

ROD AS 4647011 - Caterpillar



4647011 ROD AS Caterpillar parts ROD
Rating:
66
Alternative (cross code) number:
CA4647011
464-7011
4647011
Caterpillar 4647011 ROD AS
Weight: 0.23 pounds 0 kg.

Buy ROD AS 4647011 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 15
 
  For full view, you need register

Information:


Illustration 1 g03636920
Schematic diagram for the WIF sensor circuit
Illustration 2 g02734203
Typical view of the pin location on the P1 connector for the WIF sensor (30) WIF sensor signal
Table 1
Troubleshooting Test Steps    Values    Results    
1. Inspect Electrical Connectors and Wiring
A. Turn the keyswitch to the OFF position.
B. Thoroughly inspect the connector for the WIF sensor and the P1/J1 ECM connector. Refer to Troubleshooting, "Electrical Connectors - Inspect".
C. Perform a
30 N (10 lb) pull test on each of the wires that are associated with the WIF sensor.
D. Check the harness for abrasions, for pinch points, and for corrosion.
   
Damaged wire or connector    
Result: A damaged wire or damaged connector was found.
Repair the damaged wire or the damaged connector.
Use the electronic service tool to clear all logged diagnostic codes. Verify that the repair eliminates the fault.
Result: All connectors, pins, and sockets are correctly connected and/or inserted and the harness is free of corrosion, of abrasion or of pinch points.
Proceed to Test Step 2.
   
2. Check for Active Diagnostic Codes
A. Connect the electronic service tool to the diagnostic connector.
B. Turn the keyswitch to the ON position.
C. Wait for at least 1 minute.
D. Monitor the active diagnostic code screen on the electronic service tool. Check and record any active diagnostic codes.
   
Diagnostic codes    
Result: A 97-15 diagnostic code is active.
Ensure that there is no water present in the fuel before continuing with this procedure. Refer to Troubleshooting, "Fuel Contains Water".
Proceed to Test Step 3.
Result: A 97-15 diagnostic code is not active at this time.
If the WIF sensor is not operating correctly, proceed to Test Step 5.
   
3. Disconnect the WIF Sensor
A. Turn the keyswitch to the OFF position.
B. Disconnect the WIF sensor

Caterpillar parts catalog:

Caterpillar parts catalog
303.5E2CR Mini Hydraulic Excavator CR600001-UP (MACHINE) POWERED BY C1.7 Engine
303.5E 2CR Mini Hydraulic Excavator BG800001-UP (MACHINE) POWERED BY C1.7 Engine
303.5E2 CR Mini Hydraulic Excavator AC500001-UP (MACHINE) POWERED BY C1.7 Engine
303.5E2 CR Mini Hydraulic Excavator CR900001-UP (MACHINE) POWERED BY C1.7 Engine
303.5E2 Mini Hydraulic Excavator JWY00001-UP (MACHINE) POWERED BY C1.7 Engine
901C2 Compact Wheel Loader YKY00001-UP (MACHINE) POWERED BY C1.7 Engine


Parts rod Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.