AVSPARE.COM
parts catalog

SCREEN AS 1694890 - Caterpillar



1694890 SCREEN AS Caterpillar parts SCREEN
Rating:
16
Alternative (cross code) number:
CA1694890
169-4890
1694890
Caterpillar 1694890 SCREEN AS
Weight: 100 pounds 45 kg.

Buy SCREEN AS 1694890 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Condenser (Refrigerant)
If excessively dirty, clean condenser with a brush. To prevent damage or bending of the fins, do not use a stiff brush.Repair the fins if found defective.
The condenser is located behind the operator compartment.Note: Before the condenser is cleaned, the machine must meet the following conditions:
The battery disconnect switch must be in the OFF position.
The frame lock pin must be installed in the LOCK position.Reference: Operation and Maintenance Manual, "Battery Disconnect Switch"Reference: Operation and Maintenance Manual, "Steering Frame Lock"
Illustration 1 g06303035
Remove bolts (1) from cover (2). Remove the cover.
Inspect the condenser for debris. If necessary, clean the condenser.
Use clean water to wash off all dust and dirt from the condenser.Note: To aid in cleaning, an additive that provides degreasing may be applied. The additive must not contain ammonia.Note: If a pressure washer is used, the nozzle of the pressure washer must be no closer than 18 inches and the nozzle must be at a right angle to avoid damage.
Install cover (2). Install bolts (1).Evaporator and Heater Coils
The evaporator and heater coils are located under the seat in the cab.
Illustration 2 g06303037
Remove the access cover (1).
Illustration 3 g01378280
Remove the bolts from the modular unit (2). There are four bolts on each side of the modular unit.
Slide the modular unit along the rails.
Illustration 4 g01378285
Install links to the bolts (3).
Attach a strap to the links. Lift the modular unit and remove the modular unit.
Illustration 5 g01378287
Clean the evaporator coil (4) and clean the heater coil (5). If necessary, replace both coils.
Install the modular unit.
Install the access cover.Note: If you are operating the machine under harsh conditions or with the cab door open, it may be necessary to clean the coils more often.Radiator and Radiator Core
Illustration 6 g03880014
Open the access door on the left rear of the machine. Open the access door on the right rear of the machine.
Remove any dirt from the area around the radiators. Remove any debris from the area around the radiators.Note: You can use compressed air, high-pressure water, or steam to remove dust and other debris from the radiator core. However, the use of compressed air is preferred. See Special Publication, SEBD0518, "Know Your Cooling System" for the complete procedure for cleaning the radiator core.
Close the access doors.


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.