0005601 SCREW Caterpillar parts SCREW
Alternative (cross code) number:
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Illustration 16 g00834101
Use a suitable press in order to install gear (21) and the other components in the case. Repeat Steps 13 through 17 for the remaining gears and the other components.
Illustration 17 g00834147
Install plate (20) with bolts (19) . Tighten bolts (19) to a torque of 300 70 N m (221 52 lb ft).
Illustration 18 g01051847
Install Tooling (E) . Use Tooling (E) and a suitable lifting device in order to place carrier assembly (18) in position on the hub. The weight of the carrier assembly is approximately 75 kg (165 lb).
Install bolts (17) . Remove Tooling (E) .
Illustration 19 g00833494
Attach Tooling (E) , as shown. Remove the bolts that hold the final drive assembly to Tooling (F) . Remove the final drive assembly and position the final drive assembly in order to install the final components. Remove Tooling (E) .
Illustration 20 g00834157
Lower the temperature of bearing (16) . Install the bearing in the final drive assembly.Note: The bearing must be properly seated.
Illustration 21 g00834158
Lower the temperature of race (15) . Install the race in the final drive assembly.Note: The race must be properly seated.
Illustration 22 g00833489
Install shaft (14) in the final drive assembly.
Illustration 23 g00833486
Illustration 24 g00833239
Install O-ring seal (13) to cover (12) .
Place the cover in position and install bolts (11) .
Illustration 25 g00834159
Raise the temperature of bearing (10) . Install the bearing on the gear.
Illustration 26 g00834160
Raise the temperature of race (7) . Install the race on gear (8) , as shown. Repeat this Step for the race on the other side of gear (8) .Note: The race must be properly seated.
Illustration 27 g01238598
Install gear (9) and gear (8) in the final drive assembly.Note: Do not apply the sealant at this time.
Illustration 28 g00834305
Illustration 29 g00833234
Lower the temperature of bearing (5) . Install the bearing in cage (6) .Note: The bearing must be properly seated.
Install O-ring seal (4) , O-ring seals (2) , O-ring seal (3) , and studs (1) .End By: Install the final drive and the sprocket. Refer to Disassembly and Assembly, "Final Drive and Sprocket - Install".