1694930 SEAL Caterpillar parts CB-214D, CB-214E, CB-22, CB22B, CB24B, CB32B, CB34B, CB34B XW, CC24B, CC34B SEAL
Rating:
Alternative (cross code) number:
CA1694930
169-4930
1694930
CA1694930
169-4930
1694930
Weight: 0.01 pounds 0 kg.
COMPACTOR, VIBRATORY COMPACTOR,
Compatible equipment models: 1694930:
Number on catalog scheme:
32
For full view, you need register
Information:
Illustration 1 g02906762
Table 1
Specification for 277-8667 Front Idler Gp
Item Qty Part Specification Description
1 2 093-1414 Seal Gp Rubber toric seals and all other surfaces that contact the rubber toric seal must be clean and dry at assembly. Apply a coat of Molykote paste to the contacting surfaces of the metal seal rings prior to assembly. Seal rings must be assembled square with the bore. The rubber toric seal ring must not be bulged or twisted. Refer to Special Instruction, SEHS8364, "Assembly and Installation of Conventional Duo-Cone Seals".
2 2 5I-6274 Idler Bearing Bore diameter after assembly is
40.112 0.066 mm (1.5792 0.0026 inch).
3 2 185-9160 Spring Pin Install the pin with the slit in the range that is specified. The correct position of the pin is shown in View B-B.
Angle from centerline of shaft (C) is 20 degrees.
Specified range (D) is 40 degrees.
4 1 185-9185 Idler Shaft Install the shaft with marking "R". Position the "R" that is stamped on the end face backward into the angular bearing.
5 - - Before assembly with spring group, the surface must be clean and free of protective coating.
- - - End play is:
Minimum is
0.10 mm (0.004 inch).
Maximum is
1.20 mm (0.047 inch).