AVSPARE.COM
parts catalog

SEAL 1C3853 - Caterpillar



1C3853 SEAL Caterpillar parts SEAL
Rating:
11
Alternative (cross code) number:
CA1C3853
1C-3853
1C3853
Caterpillar 1C3853 SEAL
Weight: 0.02 pounds 0 kg.

Buy SEAL 1C3853 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


BEFORE PERFORMING ANY WORK WITH THE CAB RISER TILTED, THE RED TILT SUPPORT BRACKETS MUST BE INSTALLED. DO NOT OPERATE THE MACHINE WITH CAB RISER IN THE TILTED POSITION. PERSONAL INJURY OR DEATH COULD OCCUR.
Lower the Cab Riser.
Illustration 231. Remove the bracket 136-7080.
Illustration 24(A) Angle(B) Pilot Hoses
Illustration 25(A) Angle2. Before tilting the cab, remove the angle (A) located inside the cab riser to avoid the pilot hoses (B) to be pulled out.3. Attach a suitable lifting device to the two lifting rings located on top of the cab. The lifting rings are located in the two rear corners of the cab. The weight of the cab, platform and riser is approximately 2000 kg.4. Remove the bolts that hold the riser to the upper frame. Raise the riser until it is just past center. DO NOT APPLY EXCESSIVE LIFTING FORCE WITH THE LIFTING DEVICE. DAMAGE TO THE RISER FRAME CAN OCCUR.5. Remove the red brackets and hardware that are stored adjacent to the generator control panel in the bottom of the riser. Slowly lower the riser until the red left hand bracket (part number 130-2093) and the red right hand bracket (part number 128-8475) can be installed as shown in illustration 20. Use 8T-5460 bolts, the 8T-4123 washers and the 8T-4131 nuts to attach the brackets.
Illustration 26Raise the Cab Riser:1. Attach a suitable lifting device to the two lifting rings located on top of the cab. The lifting rings are located in the two rear corners of the cab. The weight of the cab, platform and riser is approximately 2000 kg2. Remove the two red tilt support brackets and attached hardware. Store the red brackets adjacent to the generator control panel in the bottom of the riser.3. Raise the riser until it is just past center. DO NOT APPLY EXCESSIVE LIFTING FORCE WITH THE LIFTING DEVICE. DAMAGE TO THE RISER FRAME CAN OCCUR.4. Slowly lower the riser until it is in the original position. Install the bolts that hold the riser to the upper frame and tighten the bolts.5. Remove the lifting device from the cab.6. Attach the bracket (part number 136-7080) and the angle.


Parts seal Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.