parts catalog

SEAL-PACKING 2333681 - Caterpillar

2333681 SEAL-PACKING Caterpillar parts SEAL
Alternative (cross code) number:
Caterpillar 2333681 SEAL-PACKING

Buy SEAL-PACKING 2333681 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Assembly Procedure
Note: Cleanliness is an important factor. Before the assembly procedure, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble.
Check all of the O-ring seals and the components for wear or damage. Replace the components, if necessary.
Lubricate all of the O-ring seals lightly with the lubricant that is being sealed.
Illustration 1 g00525187
Illustration 2 g00525186
Install quick-connect coupling (25) and the O-ring seal onto valve (1). Install nipple (24) and the O-ring seal onto union (25). Install cap (22) onto nipple (24).
Install fluid sampling valve (23) and the O-ring seal into valve (1).
Illustration 3 g00525146
Install orifice plug (21) into valve (1).
Illustration 4 g00525144
Install O-ring seal (20) onto valve body (16).
Install valve (15) and plate (19) into valve body (16).
Install O-ring seal (13) onto retainer (17).
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install spring (14) and hard washer (18) into valve body (16). Install retainer (17) onto valve body (16).
Install nut (12) onto retainer (17). Tighten nut (12) to a torque of 50 7 N m (37 5 lb ft).
Illustration 5 g00525137
Install O-ring seal (11) into relief valve (10). Install relief valve (10) into valve (1). Tighten relief valve (10) to a torque of 65 5 N m (47.9 3.7 lb ft).
Illustration 6 g00525129
Install O-ring seal (9) onto check valve (8).
Illustration 7 g00525128
Install check valve (8) into valve (1). Install O-ring seal (7) onto check valve (8).
Illustration 8 g00525125
Install O-ring seal (5), O-ring seal (6) and the backup ring onto cartridge assembly (3).
Illustration 9 g00525235
Illustration 10 g00525116
Install cartridge assembly (3) into valve (1). Tighten cartridge assembly (3) to a torque of 169 7 N m (124.7 5.2 lb ft).
Install coil assembly (4) into cartridge assembly (3). Position coil assembly (4), as shown. Install locknut (2) and the washer onto cartridge assembly (3). Tighten locknut (2) to a torque of 9 .5 N m (79.7 4.4 lb in). End By:
Install the steering solenoid and relief valve. Refer to Disassembly and Assembly, "Solenoid and Relief Valve (Steering) - Install".

Parts seal Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.