AVSPARE.COM
parts catalog

SEAL-PISTON 2333730 - Caterpillar



2333730 SEAL-PISTON Caterpillar parts SEAL
Rating:
41
Alternative (cross code) number:
CA2333730
233-3730
2333730
Caterpillar 2333730 SEAL-PISTON
Weight: 0.09 pounds 0 kg.

Buy SEAL-PISTON 2333730 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Press and hold "SET UP/SELECT" switch (1) for three seconds in order to enter mode 1. Release the switch when you hear a beep. Press the "SET UP/SELECT" switch in order to scroll to the display for "IMP CAL" (25). If the display is not set to "00" (26) press the "START/STOP" switch (9) for three seconds. This will reset the threshold value to zero. The measurement for the accumulation of area is now controlled by the "START/STOP" switch. Next, enter the width of the implement. Press the "SET UP/SELECT" switch in order to scroll to the display for "IMP WIDTH CAL" (5). See Operation and Maintenance Manual, "Programming Electronic Monitoring Center-Setting Implement Width" for the procedure that is used to set the width of the implement. Press the "EM" switch twice in order to exit mode 1 and return to normal operation.The accumulated area can be displayed by pressing "AREA" symbol (27) on the Machine Performance Monitor. The display indicates the total of the worked area for the machine. A "FT" symbol (6) indicates that the area is measured in acres. A "METERS" symbol (6) indicates that the area is measured in hectares. The word "AREA" (28) and the word "ON" (29) will be displayed while the Machine Performance Monitor is accumulating the area. Pressing the "START/STOP" switch (9) will stop the accumulation of area. The word "OFF" (30) indicates that the accumulation of area is stopped. Holding down the "START/STOP" switch (9) for three seconds will zero the accumulation of area. An audible beep will sound.Position of the Three-Point Hitch Rockshaft
Illustration 15 g00635479
Illustration 16 g00635358
Press and hold "SET UP/SELECT" switch (1) again for three seconds in order to enter mode 1. Release the switch when you hear a beep. Press the "SET UP/SELECT" switch in order to scroll to the display for "IMP CAL" (25). This will reset the threshold value to zero. Next, enter a threshold value that is in the range of 1 to 98 percent. The measurement for the accumulation of area is now controlled by the position of the three-point hitch rockshaft. Next, enter the width of the implement. Press the "SET UP/SELECT" switch in order to scroll to the display for "IMP WIDTH CAL" (5). See Operation and Maintenance Manual, "Programming Electronic Monitoring Center-Setting Implement Width" for the procedure that is used to set the width of the implement. Press the "E/M" switch twice in order to exit mode 1 and return to normal operation.Note: When you are programming the EMC, use "DIGIT SELECT" switch (7) and "DIGIT SET" switch (8) in order to change the value of a flashing digit. Pressing the "DIGIT SET" switch (8) increases the value of the flashing digit. The value that is shown will cycle between zero and the highest digit that is available for that function. Pressing the "DIGIT SELECT"


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.