AVSPARE.COM
parts catalog

SEAL-PISTON 2333880 - Caterpillar



2333880 SEAL-PISTON Caterpillar parts SEAL
Rating:
51
Alternative (cross code) number:
CA2333880
233-3880
2333880
Caterpillar 2333880 SEAL-PISTON

Buy SEAL-PISTON 2333880 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     1    
Mark the harness assemblies for installation purposes.
Illustration 1 g00537108
Disconnect harness assembly (1) and (2) from alternator (3) .
Illustration 2 g01013845
Disconnect ground cable (4) from alternator (3) .
Remove nut (5), (11), and (13) .
Remove guard (9) from alternator (3) .
Remove outer nut (7) from bolt (8) .
Loosen the inner nut (not shown) on bolt (8) until the alternator belt can be removed from the alternator pulley.
Attach Tooling (A) and a suitable lifting device to the alternator. Remove bolts (6), (10), and (12) and alternator (3). The alternator weighs approximately 16 kg (35 lb).
If alternator bracket (14) must be removed, disconnect the grease line junction block. Remove the alternator bracket.Installation Procedure
Illustration 3 g01013845
Install the alternator bracket (14) .
Install the grease line junction block if the junction block was removed.
Illustration 4 g00537108
Position alternator (3) on bracket (14) and bolt (8). Position the alternator belt on the alternator pulley. Install bolt (10), bolt (12), and outer nut (7). Do not tighten nut (7) .
Install guard (9) and nut (5) and (13) on bolts (6) and (12). Do not tighten nut (5) and (13) .
Use the inner nut (not shown) on bolt (8) to adjust the tension of the alternator belt. Use a BT-33-95 belt tension gauge from Borroughs Tool Company or an equivalent part in order to check the tension of the belt. The correct belt tension is 535 22 N (120 5 lb) for a new belt and 400 44 N (90 10 lb) for a used belt.
After the proper belt tension has been obtained, tighten nut (5) and (13). Tighten outer nut (7) .
Connect harness assemblies (1) and (2). Connect ground cable (4) .Note: After the wires are connected to the alternator, tighten the nut that secures wire (2) to a torque of 7.0 0.8 N m (62 7 lb in). Tighten the nut that secures ground cable (4) to a torque of 6 1 N m (55 5 lb in).


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.