AVSPARE.COM
parts catalog

SEAL-PISTON 2333904 - Caterpillar



2333904 SEAL-PISTON Caterpillar parts SEAL
Rating:
61
Alternative (cross code) number:
CA2333904
233-3904
2333904
Caterpillar 2333904 SEAL-PISTON

Buy SEAL-PISTON 2333904 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Start By:
Release the air system pressure. Refer to Disassembly and Assembly, "Air Tanks (Brake) - Purge".
In order to prevent possible personal injury, release the air pressure from the air tank before disconnecting any components of the air system.
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all hose assemblies and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss and this helps to prevent contaminants from entering the system.
Illustration 1 g00538795
Illustration 2 g00538882
Disconnect hose assembly (1) from the adapter on air horn (2).
Remove bolt (3), the washer and nut (4).
Remove nut (6), the lockwasher and the washer in order to remove air horn (2) and cushion (5). Installation Procedure
Note: Cleanliness is an important factor. Before the installation procedure, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble.
Illustration 3 g00538795
Illustration 4 g00538882
Use nut (6), the lockwasher and the washer in order to install air horn (2) and cushion (5). Tighten nut (6) to a torque of 50 8 N m (37 6 lb ft).
Install bolt (3), the washer and nut (4).
Connect hose assembly (1) to the adapter on air horn (2).
Charge the air pressure in the air tanks. Refer to Operation and Maintenance Manual, SEBU7173, "Starting with an External Air Supply" in order to refill the air tanks. End By:
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.