AVSPARE.COM
parts catalog

SEAL-PISTON 2333912 - Caterpillar



2333912 SEAL-PISTON Caterpillar parts SEAL
Rating:
21
Alternative (cross code) number:
CA2333912
233-3912
2333912
Caterpillar 2333912 SEAL-PISTON

Buy SEAL-PISTON 2333912 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Illustration 1 g00538937
Remove bolt (1) and two hard washers in order to disconnect rod assembly (2) from truck body (3).
Illustration 2 g00539865
Illustration 3 g00539866
Disconnect wire harness (7) from the sensor buffer at the electrical connection.
Remove five bolts (6) and the hard washers in order to remove potentiometer assembly (4) and plate (5) from the frame assembly.
Remove bolt (9), the nut and two hard washers in order to remove rod assembly (2) from lever (8).
Illustration 4 g00539868
Remove bolt (11), the nut and two hard washers in order to remove lever (8) from the shaft of potentiometer assembly (4).
Remove woodruff key (10) (not shown) from the shaft of potentiometer assembly (4). Installation Procedure
Verify that all of the components of the potentiometer assembly are clean and free of foreign material prior to installation.
Inspect all of the components for wear and replace the components, if necessary.
Illustration 5 g00539871
Adjust the length of rod assembly (2). Refer to Power Train Electronic Control System, Systems Operation/Testing and Adjusting, SENR1502, "Body Position Sensor Calibration" for the correct procedure.
Illustration 6 g00539868
Install woodruff key (10) (not shown) into the shaft of potentiometer assembly (4).
Align the slot on lever (8) with woodruff key (10). Position lever (8) onto potentiometer assembly (4). Use bolt (11), the nut and two hard washers in order to install lever (8) onto potentiometer assembly (4).
Illustration 7 g00539866
Illustration 8 g00539865
Use bolt (9), the nut and two hard washers in order to install rod assembly (2) to lever (8).
Use five bolts (6) and the hard washers in order to install plate (5) and potentiometer assembly (4) to the frame assembly, as shown.
Connect wire harness (7) to the sensor buffer at the electrical connection.
Illustration 9 g00538937
Use bolt (1) and two hard washers in order to connect rod assembly (2) to truck body (3).


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.