parts catalog

SEAL-ROD 2333931 - Caterpillar

2333931 SEAL-ROD Caterpillar parts SEAL
Alternative (cross code) number:
Caterpillar 2333931 SEAL-ROD

Buy SEAL-ROD 2333931 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Illustration 41 g00589774
Place the jacks under the front end and raise the truck .
Illustration 42 g00550144
Remove the nuts and washers and remove the tire.ReferenceRefer to Disassembly and Assembly, SENR1463 for the removal and installation of the front wheel bearings and duo-cone seal kits.ReferenceRefer to Table 6 for Illustration 40.
Illustration 43 g00589778
This is a view of the 160-7629 Studs (40) that are installed.
Replace the old studs with new 160-7629 Studs (40) .
Illustration 44 g00546564
Install the 160-4734 Spacer (39) .
Clean both sides of the 160-4734 Spacer (39) and mount the spacer onto the hub.
Mount the tire and rim. Install the 6V-8237 Hard Washers (41) and the 7X-0851 Nuts (42). Secure the nuts with an air gun.
Illustration 45 g00546572
Install the front tire.
Torque the nuts to 1000 125 N m (735 92 lb ft).
Repeat these steps on the other front tire.Installation of the Rear Wheel Rim Mounting Group and the Front Wheel Rim Mounting Group
Table 7
Parts for the 173-4034 Tire Arrangement (Rear Wheel Rim Mounting Parts)    
Item     Qty     Part Number     Description     Model Specific    
59     2     161-5736     Bracket     All Models    
60     2     161-5738     Extension     All Models    
61     4     8T-0342     Bolt     All Models    
62     2     8X-6127     Hose Assembly     All Models    
63     4     6J-0427     Spacer     All Models    
64     2     5T-9796     Connector     All Models    
Table 8
Parts for the 173-4034 Tire Arrangement (Front Wheel Rim Mounting Parts)    
Item     Qty     Part Number     Description     Model Specific    
65     2     8W-0331     Swivel Connector     All Models    
66     6     5T-9790     Valve Group     All Models    
Lower the jacks and remove the jacks.Note: Installation of the rim assemblies and tires is normally done by the shop tire installer. Note: The rim assemblies and tires are assembled at the site. Remove grease, burrs, and nicks from the wheel and rim mounting areas. Clean the surfaces with solvent. Clean the surfaces with 4C-4188 Paint Remover .
Refer to Table 7 and Table 8 for Illustration 46.
Illustration 46 g00588068

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.