AVSPARE.COM
parts catalog

SEAL-ROD 2333934 - Caterpillar



2333934 SEAL-ROD Caterpillar parts SEAL
Rating:
11
Alternative (cross code) number:
CA2333934
233-3934
2333934
Caterpillar 2333934 SEAL-ROD

Buy SEAL-ROD 2333934 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-6486     Stand     2    
8S-7631 Tube     2    
8S-7615 Pin     2    
B     N/A     1/2 in NC Guide Bolts     2    Start By:
Remove the fan and the fan guards. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.
Remove the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove" for the correct procedure.Note: If the front of the engine will be raised by more than 6 mm (0.24 inch), the following steps must be performed in order to prevent damage to the components of the machine:
Disconnect the drive shaft from the pump drive. Refer to Disassembly and Assembly for the correct procedure.
Remove the front guard for the main drive shaft. Refer to Disassembly and Assembly, "Drive Shaft Guard (Front) - Remove and Install" for the correct procedure.
Loosen the hose clamps of the hose that connects the torque converter pump suction tube to the hydraulic tank. Refer to Disassembly and Assembly, "Torque Converter - Remove".
Loosen the hose clamps of the rubber elbow that connects the air inlet tubes to the air cleaners.
Loosen the hose clamps of the hoses that connect the engine water pump and the auxiliary water pump to the radiator.
Loosen the caps on the rear engine mounts.
Remove the exhaust piping that connects the turbochargers to the rear main frame.
Illustration 1 g00540168
Remove bolts (2) that fasten trunnion (1) to the engine front support.
Illustration 2 g01013343
Use a suitable lifting device to raise the front of the engine until all the weight is removed from trunnion (1). The front of the engine weighs approximately 4500 kg (99201 lb).
Position Tooling (A) under the front drive housing, as shown.
Remove two bolts (3). Install Tooling (B) .
Remove the remainder of bolts (3) from trunnion (1) .
Illustration 3 g00540170
Pull trunnion (1) away from the front drive housing.
Use a suitable lifting device to remove trunnion (1) from the engine. The trunnion weighs approximately 54 kg (119 lb).
Illustration 4 g00540171
Remove bolts (5) and mount assembly (6) from support (7) .


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.