AVSPARE.COM
parts catalog

SEAL, POCKET 70000128 - Caterpillar



70000128 SEAL, POCKET Caterpillar parts CB-414, TSF-54, TSM-54 SEAL
Rating:
72
Alternative (cross code) number:
CA70000128
7000-0128
70000128
Caterpillar 70000128 SEAL, POCKET

Buy SEAL, POCKET 70000128 Caterpillar genuine, new aftermarket tractor parts with delivery
VIBRATORY COMPACTOR,

Compatible equipment models: 70000128:

VIBRATORY COMPACTOR  CB-414   TSF-54   TSM-54   Caterpillar
Number on catalog scheme: 11
 
  For full view, you need register

Information:

Probable Causes
Diagnostic codes
Event codes
Flash file
Power supply for the Electronic Control Module (ECM)
Starting circuit
Starting aids (if applicable)
Engine shutdown switches (if applicable)
Air shutoff system (if applicable)
Engine speed/timing
Unit injectors
Fuel supply
CombustionRecommended Actions
Diagnostic Codes, Event Codes, and ECM Power Supply
Certain diagnostic codes and/or event codes may prevent the engine from starting. Connect the Caterpillar Electronic Technician (ET) and check for active codes and/or for logged codes. Troubleshoot any codes that are present before continuing with this procedure.Note: If Cat ET will not communicate with the ECM, the problem is most likely with the electrical power supply to the ECM. Refer to diagnostic functional tests Troubleshooting, "Electrical Power Supply Circuit - Test".Starting Circuit
Test the operation of the starting motor solenoid.
Check the engine wiring to the starting motor solenoid.
Test the operation of the starting motor.
Inspect the starting motor pinion and the flywheel ring gear for damage.Flash File
Verify that the correct flash file has been flashed into the ECM. Refer to programming parameters Troubleshooting, "Flash Programming" for additional information.Starting Aids
Air Inlet Heater (if applicable)
Make sure that the air inlet heater is programmed to the On position. For additional information on the air inlet heater, refer to diagnostic functional tests Troubleshooting, "Air Inlet Heater Circuit - Test".Engine Shutdown Switches (If Applicable)
The engine shutdown switches should be in the OFF position. Use Cat ET to verify the status of the shutdown switches. When a shutdown occurs, the engine control must be in the OFF/RESET mode for at least 15 seconds before restarting the engine.Note: If Cat ET will not communicate with the ECM, the problem is most likely with the electrical power supply to the ECM. Refer to diagnostic functional tests Troubleshooting, "Electrical Power Supply Circuit - Test".Air Shutoff System (If Applicable)
Check the air shutoff mechanism. If an engine overspeed has occurred, the keyswitch must be cycled. There may be a manual reset for the air shutoff mechanism that is on the engine.Engine Speed/Timing
Crank the engine and observe the engine speed on the Cat ET status screen. If Cat ET indicates zero rpm, refer to diagnostic functional tests Troubleshooting, "Engine Speed/Timing Sensor Circuit - Test".Note: Upon initial cranking, the status for engine speed may indicate that the engine speed signal is abnormal. This message will be replaced with an engine speed once the ECM is able to calculate a speed from the signal.
Ensure that the timing reference gear is installed correctly. The engine will not start if the gear was installed backward. Check for proper orientation between the crankshaft and camshaft drive gears. Correct the orientation and/or replace the drive gear, if necessary. Refer to the Disassembly and Assembly manual for additional information.Unit Injectors
Perform the "Injector Solenoid Test" on Cat ET in order to determine if all of the injector solenoids are being energized by the ECM. Refer to diagnostic functional tests Troubleshooting, "Injector Solenoid Circuit - Test" for additional information.Verify that the injection system is delivering the correct pressure. Refer to diagnostic functional tests Troubleshooting, "Injection Actuation Pressure - Test" for additional information.Fuel Supply
Visually check the fuel

Caterpillar parts catalog:

Caterpillar parts catalog
CB-414 VIBRATORY COMPACTOR 6KD00001-UP (MACHINE) POWERED BY 4239D ENGINE
TSM-54 VIBRATORY COMPACTOR 7LD00001-UP (MACHINE) POWERED BY F2L-511D ENGINE
TSF-54 VIBRATORY COMPACTOR 7KD00001-UP (MACHINE) POWERED BY F2L-511D ENGINE


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.