SENSOR GP- 4646780 - Caterpillar

Removal Procedure
Start By:
Remove the track drive motor from the right side of the machine. Refer to Disassembly and Assembly, "Track Drive Motor - Remove".Note: Put identification marks on all hoses, on all hose assemblies, on all harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. this helps to prevent fluid loss, and this helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g01330748
Use two people to remove cover assembly (1). The weight of cover assembly (1) is approximately 24 kg (52 lb). Remove plate assembly (2) .
Illustration 2 g01330753
Disconnect hose assemblies (3). Remove tube assemblies (4) .
Illustration 3 g01330780
Disconnect harness assemblies (5) .
Illustration 4 g01330794
Disconnect tube assemblies (6) .