AVSPARE.COM
parts catalog

SFWR GP-A1000 4645941 - Caterpillar



4645941 SFWR GP-A1000 Caterpillar parts SFWR
Rating:
16
Alternative (cross code) number:
CA4645941
464-5941
4645941
Caterpillar 4645941 SFWR GP-A1000

Buy SFWR GP-A1000 4645941 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 1 g01156521
Two devices with the same serial number that are connected to the AccuGrade - Grade Control System are detected as the same device. For example, two left electric masts are detected.Test Step 1. VERIFY THE SERIAL NUMBER OF THE DEVICEMake a visual check of each device label in order to ensure that each device has a different serial number.Expected Result:Each device has a separate serial number.Results:
OK - Each device has a separate serial number. Proceed to Test Step 2.
NOT OK - There is a duplicate serial number.Repair: Replace the affected component.STOPTest Step 2. VERIFY THE ELECTRONIC SERIAL NUMBER FOR EACH DEVICE
Connect Caterpillar Electronic Technician (ET) to the machine service connector.
Verify that the devices do not have duplicate electronic serial numbers.Expected Result:There are no duplicate electronic serial numbers.Results:
OK - There are no duplicate serial numbers. Proceed to Test Step 3.
NOT OK - Repair: Replace the affected device.STOPTest Step 3. CHECK THE HARNESS FOR AN OPEN.
Turn the key start switch and the disconnect switch for the machine to the OFF position.
Disconnect the harness from the knuckle connector that is located on the right side.
Measure the resistance between pin "B" and pin "F".Expected Result:The resistance is less than 5.0 ohms.Results:
OK - The resistance is less than 5.0 ohms. The machine harness is correct. Proceed to Test Step 4.
NOT OK - The resistance is greater than 5000 ohms. The resistance measurement is not correct. There is an open circuit in the machine harness.Repair: The open is in wire T745-YL of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 4. CHECK THE HARNESS FOR A SHORT.
Turn the key start switch and the disconnect switch for the machine to the OFF position.
Disconnect the harness from the knuckle connector that is located on the left side.
Measure the resistance between pin "B" and pin "F".Expected Result:The resistance is greater than 5000 ohms.Results:
OK - The resistance is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 5.
NOT OK - The resistance is less than 5000 ohms. The resistance measurement is not correct. There is an short circuit in the machine harness.Repair: The short is in wire T748-PK of the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 5. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the contacts of


Parts sfwr Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.