AVSPARE.COM
parts catalog

SHAFT 1C4280 - Caterpillar



1C4280 SHAFT Caterpillar parts SHAFT
Rating:
11
Alternative (cross code) number:
CA1C4280
1C-4280
1C4280
Caterpillar 1C4280 SHAFT
Weight: 2 pounds 1 kg.

Buy SHAFT 1C4280 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

20. If necessary, heat race (24), and remove it from shaft (23).21. Remove turbine (22) from shaft (23). 22. Use Tool (B) to remove ring (28) from the shaft.23. Remove six bolts (25), two plates (27) and stator (26). 24. Remove six bolts (30), two plates (29) and impeller (19). 25. Remove gear assembly (31) from carrier (32). 26. Remove bearing (33) from gear assembly (31). 27. Remove ring (34) that holds shaft (23) and the bearing in place in carrier (32). 28. Use a press, and remove shaft (23) and the bearing from carrier (32). 29. If necessary, remove pins (35) and sleeve (36) from carrier (32). 30. Remove bearing (37) and ring (38) from shaft (23).Assemble Torque Converter
1. Install ring (3) and bearing (2) on shaft (1). 2. If sleeve (5) was removed from the carrier, align the tab on the sleeve with the notch in the carrier, and install the sleeve in carrier (6).3. If pins (4) were removed, install the pins in carrier (6). 4. Use a press and Tool (A), and install the shaft and bearing (2) in carrier (6). 5. Install ring (7) in carrier (6) to hold bearing (2) in place. 6. Install bearing (9) in gear assembly (8). Install the bearing until dimension (X) is 1.5 0.5 mm (.06 .02 in). The inside diameter of the bearing must be 89.027 0.038 mm (3.5050 .0015 in) after installation. 7. Put gear assembly (8) in position on carrier (6). 8. Check the clearance between the stator and turbine as follows: a. Put turbine (10) on a smooth, flat surface. Install four 1B4330 Nuts (11) evenly spaced in the turbine as shown. b. Put stator (12) in position in turbine (10) as shown.c. Put Tooling (B) against the stator as shown. Move the stator toward Tooling (B) until it makes contact with the inside diameter in the turbine. Adjust the dial indicator


Parts shaft Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.