AVSPARE.COM
parts catalog

SHIM 9W0288 - Caterpillar



9W0288 SHIM Caterpillar parts SHIM
Rating:
61
Alternative (cross code) number:
CA9W0288
9W-0288
9W0288
Caterpillar 9W0288 SHIM
Weight: 11 pounds 5 kg.

Buy SHIM 9W0288 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

1. Remove the bolts, and install two 3/8" - 16 NC forcing screws to remove adapter assembly (1) from the front drive housing. 2. Remove bolts (2), and pull adapter assembly (3) and the gears from the front drive housing as a unit. The weight of the unit is 23 kg (50 lb). The following steps are for installation of the oil and water pump drive. 3. Make sure the O-ring seals are installed on the grooves of adapter assembly (3), and put clean engine oil on the seals.4. Put the gears and adapter assembly (3) in position as a unit. Make sure the drive gear is engaged correctly with the idler gear, and tighten the bolts to hold adapter assembly (3) in position. 5. Make sure the O-ring seal is installed in the groove of adapter assembly (1), and put clean engine oil on it.6. Put adapter assembly (1) in position, and install the bolts to hold it to the front drive housing.End By:a. install oil pumpb. install water pumpDisassemble And Assemble Oil And Water Pump Drive
Start By:a. remove oil and water pump drive 1. Remove oil pump O-ring seal (4) from adapter (3).2. Remove washer (2). Remove adapter (3) from shaft assembly (1). 3. Remove O-ring seals (6) and (7) from adapter (3).4. Use a press and tool group (A) to remove bearing (5) from adapter (3). 5. Remove bolts (9) to remove gears (8) and (10) from shaft assembly (1). 6. Remove O-ring seal (13) from the water pump adapter assembly (12).7. Use a press and tool group (A) to remove bearing (11) from adapter assembly (12). The following steps are for assembly of the oil and water pump drive.8. Lower the temperature of bearing (11) for water pump adapter (12). Use tool group (A), and install the bearing in adapter (12). Check the bore in the bearing after assembly. The bore in the bearing must be 75.00 0.06 mm (2.953 .002 in). Install O-ring seal (13) on adapter (12).9. Put gears (8) and (10) in position on the shaft assembly as shown, and install the bolts to hold the unit together.10. Lower the temperature of bearing (5) for adapter (3). Align the oil hole in the bearing with the oil hole in adapter (3), and use tool group (A) to install the bearing. Make sure the bearing does not extend beyond the surface shown, and the inside diameter is 75.00 0.06 mm (2.953 .002 in) after installation.11. Install O-ring seals (6) and (7) on adapter (3). 12. Put adapter (3) in position on shaft assembly (1), and install washers (2) to hold the unit together.13. Install the oil pump O-ring seal (4) on adapter (3).End By:a. install oil and water pump drive


Parts shim Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.