SHIM 9W0294 - Caterpillar

1. Remove bolts (3), and remove pulley (1) from the drive shaft2. Remove bolts (2), and use two 1/2" - 13 NC forcing screws to remove adapter assembly (4) from the rear of the front drive housing. 3. Remove bolts (5), and remove accessory drive (6) from the front drive housing. The following steps are for installation of the accessory drive (front). 4. Make sure the O-ring seals are in position on accessory drive (6), and put clean engine oil on them.5. Install accessory drive (6) in the front drive housing. Make sure the teeth of the gear on the accessory drive are engaged correctly with the teeth of the gear in the front housing. Install the bolts to hold accessory drive (6) in position.6. Make sure the two O-ring seals are installed on adapter assembly (4), and put clean engine oil on them. Put clean oil on the lip of the seal and bearing in adapter assembly (4), and install the adapter assembly on the rear of the front drive housing. Tighten bolts (2) to hold adapter assembly (4) in position.7. Put pulley (1) in position, and install the bolts to hold it to the drive shaftEnd By:a. install oil pumpb. install governor driveDisassemble Accessory Drive (Front)
Start By:a. remove accessory drive (front) 1. Remove O-ring seals (2) and (3) from adapter (1). 2. Remove seal (4) from adapter (1). Use a press and tool group (A) to remove bearing (5) from adapter (1). 3. Remove bolts (7) to remove gear (8) from shaft (6). 4. Remove bolts (9) and the retainer washer to remove shaft (6) from adapter (10). 5. Remove O-ring seals (12) and (13) from adapter (10).6. Use a press and tool group (A) to remove bearing (11) from adapter (10).