AVSPARE.COM
parts catalog

SPACER 3598668 - Caterpillar



3598668 SPACER Caterpillar parts 320E SPACER
Rating:
28
Alternative (cross code) number:
CA3598668
359-8668
3598668
Caterpillar 3598668 SPACER

Buy SPACER 3598668 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 3598668:

EXCAVATOR  320E   Caterpillar
Number on catalog scheme: 9
 
  For full view, you need register

Information:


Release all the pressure in the hydraulic system prior to disconnecting any hydraulic oil lines. If the oil pressure is not released completely, oil can spray out of the lines under high pressure. Failure to release system pressure completely can cause personal injury.
2. Lower the lift arms to the ground and make sure all hydraulic system pressure is released.
Typical Example3. Remove the cover from the coupler to provide access to the coupler cylinder.4. Mark the location of two hoses (1), and disconnect them from coupler cylinder (2).5. Unscrew pins (3) from each end of the cylinder, and remove coupler cylinder (2).6. Remove the two bolts from the back of the coupler assembly, and remove plate (4) and two pins (3).7. Install coupler cylinder (2) in the reverse order of removal.
When assembled, plate (4) must not contact the cylinder rod when pins (3) are retracted or extended.
Disassemble & Assemble Coupler Cylinder (Quick)
Start By:a. remove coupler cylinder (quick) 1. Remove spiral ring (4) and nylon ring (3).2. Tap head assembly (1) toward the inside of the cylinder until spiral ring (2) can be removed.3. Remove spiral ring (2), and pull the rod, head and piston assembly from the cylinder housing. 4. Remove nut (9) and piston (8) from rod (5).5. Remove seal (7) and two rings (6) from piston (8). 6. Remove seal (10) from rod (5), and slide head assembly (1) from the rod. 7. Remove seal (11), seal (12) and seal (13) from the head assembly. The following steps are for the assembly of the coupler cylinder.8. Check all seals for wear or damage and install a new seal kit if necessary. Lubricate all seals with clean hydraulic oil during assembly.9. Assemble the coupler cylinder in the reverse order of disassembly.10. Install seal (12) with the lip pointing down. Install seal (11) with the lip pointing up toward the outside of the cylinder.11. Tighten nut (9) to a torque of 68 7 N m (50 5 lb ft).End By:a. install coupler cylinder (quick)

Caterpillar parts catalog:

Caterpillar parts catalog
320E & 320E L Excavators AWS00001-UP (MACHINE) POWERED BY C6.6 Engine


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.