AVSPARE.COM
parts catalog

SPECIAL AR 3157231 - Caterpillar



3157231 SPECIAL AR Caterpillar parts SPECIAL
Rating:
56
Alternative (cross code) number:
CA3157231
315-7231
3157231
Caterpillar 3157231 SPECIAL AR

Buy SPECIAL AR 3157231 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 13 g02585659
Press down key (14) until "Calibrations" is highlighted on the display screen.
Press OK key (15) .
Illustration 14 g02585677
Press down key (14) until "Vibe Motor Sol" is highlighted on the display screen.
Press OK key (15) .
Illustration 15 g02585679
Press OK key (15) to begin the calibration.
Illustration 16 g02585685
Move parking brake switch (2) to the ON position.
Move throttle control switch (9) to the HIGH IDLE position twice. For each switch actuation, hold the switch in this position for less than 1 second. The engine speed should increase to 2200 rpm.
Illustration 17 g02585686
Move vibratory switch (16) on the left instrument panel to the ON position.Note: The parking brake should be in the ON position during this operation.
Illustration 18 g02585688
Squeeze trigger (17), and move propel lever (1) to the FORWARD position.
Press OK key (15) .
Illustration 19 g02585691
Illustration 20 g02585693
Right Operator Control Station on AS2302C Screed
Illustration 21 g02585694
Right Operator Control Station on AS3301C Screed
Illustration 22 g02585696
Center Operator Control Station on AS4252C Screed
Rotate vibratory speed dial (18) on the right screed operator station to the MINIMUM position.
Press OK key (15) .
Illustration 23 g02585697
Rotate vibratory speed dial (18) on the screed operator panel clockwise until the vibratory just begins to operate.
Press OK key (15) .
Illustration 24 g02585698
Rotate vibratory speed dial (18) on the screed operator panel clockwise until the speed of the vibratory shaft reaches 3000 300 rpm. Use Tool (A) to measure the speed.
Press OK key (15) .
Illustration 25 g02585701
The display should now read "CALIBRATION COMPLETE". Push back key (19) to return to calibration screen.Note: If the vibratory motor speed cannot be achieved during the calibration, replace the vibratory motor solenoid valve and retest.
Push home key (13) to exit the calibration screen.
Move propel lever (1) to the NEUTRAL position.
Move vibratory switch (16) on the left instrument panel to the OFF position.
Move throttle control switch (9) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (10) to the OFF position.
If the machine is equipped with an AS2302C Screed, hold plate in position, and replace two bolts (11) and washers.


Parts special Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.