0001555 SPRING Caterpillar parts SPRING
Alternative (cross code) number:
Illustration 1 g00513776
Schematic of the temperature sensor (hydraulic oil)This diagnostic code is associated with the temperature sensor (hydraulic oil). The FMI 03 means that the ECM has determined that the voltage of the circuit for the sensor is above normal.The output of the sensor is approximately 500 Hz. The duty cycle of the signal varies as the temperature of the hydraulic oil changes. The duty cycle varies from 9% to 91%.The possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is open.
The signal circuit for the sensor is shorted to the +battery circuit.
The sensor has failed.
The power circuit or the ground circuit has failed.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0600 FMI 03 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code of CID 0600 FMI 03 will be logged in the internal memory of the Caterpillar Monitoring System ECM.Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the voltage supply wire (contact A).
Measure the voltage from contact A to frame ground.Expected Result:The voltage is 8 DCV.Results:
OK - The voltage is 8 DCV. Proceed to Test Step 2.
NOT OK - The voltage is not 8 DCV. The + battery circuit in the machine harness has failed.Repair: Replace the machine harness or repair the machine harness.STOPTest Step 2. CHECK FOR PROPER GROUND AT THE SENSOR.
The machine harness remains connected to the sensor.
Turn the key start switch and the disconnect switch to the OFF position.
Remove the 7X-1710 Multimeter Probe from the voltage supply wire (contact A).
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the ground wire (contact B).
Measure the resistance from contact B to frame ground.Expected Result:The resistance is less