AVSPARE.COM
parts catalog

SPRING 0005641 - Caterpillar



0005641 SPRING Caterpillar parts SPRING
Rating:
76
Alternative (cross code) number:
CA0005641
000-5641
0005641
Caterpillar 0005641 SPRING
Weight: 0.51 pounds 0 kg.

Buy SPRING 0005641 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Start By:
Remove the cab. Refer to Disassembly and Assembly, "Cab - Remove".
Table 1
Tools Needed    
Tool     Part Number     Part Description     Qty    
A     138-7573     Link Bracket     1    
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the hydraulic system oil. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Illustration 1 g00828548
Remove bolts (1), the washers and bracket (2). Move the bracket, filters, and hose aside.
Loosen hose clamp (3) and disconnect hose (4) from the hydraulic tank assembly.
Illustration 2 g00828550
Remove the bolt and the clamps, which secure tube assemblies (5) (if equipped) to the side of the hydraulic tank assembly.
Remove hose assembly (8) from the hydraulic tank assembly.
Cut the cable straps that secure harness assembly (6) to the hydraulic tank assembly. Disconnect the harness assembly from sending unit (7) .Note: You can access bolts (9) through two access holes in the right hand plate above the tracks.
Remove bolts (9) and (9A) that secure the hydraulic tank assembly in position.
Illustration 3 g00828551
Use Tooling (A) and a suitable lifting device in order to remove the hydraulic tank assembly (10). The weight of the hydraulic tank assembly is approximately 45 kg (100 lb).


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.