AVSPARE.COM
parts catalog

SPRING, RELIEF VALVE 7097034C1 - Caterpillar



7097034C1 SPRING, RELIEF VALVE Caterpillar parts SPRING
Rating:
21
Alternative (cross code) number:
CA7097034C1
70970-34C1
7097034C1
Caterpillar 7097034C1 SPRING, RELIEF VALVE

Buy SPRING, RELIEF VALVE 7097034C1 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Disassembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     4C-6486     Stand     1    
8S-7621 Tube     1    
8S-7615 Pin     1    
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Put identification marks on all hoses, on all lines and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00928851
Install Tooling (A) at the underside of boom (1) .
Illustration 2 g00928853
Remove cover plate (2) from quick coupler (3) .
Illustration 3 g00928854
Disconnect two hoses (4) from hitch cylinder (5). Remove tube (6) from the hitch cylinder.
Illustration 4 g00928855
Remove two bolts (7), the washers and retaining plate (8) .
Illustration 5 g00928856
Rotate hitch cylinder (5) and at the same time push the hitch cylinder toward the left side of the machine. Use a suitable punch to drive dowel (10) through pin (9) as far as possible. Make sure that dowel (10) is clear of the rod of hitch cylinder (5). Dowel (10) will still be partially installed in pin (9) .
Illustration 6 g00929187
Remove pin (9) and dowel (10) .
Illustration 7 g00929188
Push hitch cylinder (5) toward the right side of the machine. Use a suitable punch to drive dowel (12) through pin (11) as far as possible. Make sure that dowel (12) is clear of the rod of hitch cylinder (5). Dowel (12) will be still partially installed in pin (11) .
Illustration 8 g00929189
Remove pin (11) and dowel (12) .
Illustration 9 g00929190
Remove hitch cylinder (5) from quick coupler (3) .

Caterpillar parts catalog:



Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.