SPRING 9V8949 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 1P-1861 Retaining Ring Pliers 1
D 1P-0766 Seal Guide 1
E 139-0088 Seal Installer 1
F 169-5464 Quick Cure Primer -
Illustration 1 g01766957
Illustration 2 g01768596
Use Tooling (F) in order to clean shaft (5) and the counterbore in housing (3).
Use Tooling (D) and a suitable press to install lip seal (4) in housing (3). Install the lip seal with the lip toward the gear. Ensure that the lip seal is flush with the housing. Do not lubricate the lip seal.
Use a suitable press to install bearing (6) onto shaft (5).
Use a suitable press to install shaft (5) and bearing (6) into housing (3).
Use Tooling (B) to install retaining ring (7).
Use Tooling (E) and a suitable press to install seal group (2) onto shaft (5). Ensure that the seal group is flush against the housing. Note: Ensure that the end of the shaft is supported during installation.
Use a suitable press in order to install impeller (1) onto shaft (5). The top of impeller (1) should be installed to Depth (X) below the surface of the housing. Depth (X) is 10.92 0.13 mm (0.43 0.00512 inch).
Use a suitable press in order to install gear (8) onto shaft (5).
Install bearing (9). Ensure that the bearing is flush with the gear.
Install the washer and bolt (10). End By:
Install the water pump.