AVSPARE.COM
parts catalog

SUPPORT AS 2333216 - Caterpillar



2333216 SUPPORT AS Caterpillar parts SUPPORT
Rating:
26
Alternative (cross code) number:
CA2333216
233-3216
2333216
Caterpillar 2333216 SUPPORT AS

Buy SUPPORT AS 2333216 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Start By:
Remove the evaporator coil. Refer to Disassembly and Assembly, "Evaporator Coil - Remove and Install". Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00576775
Remove bolt (3) and the washer.
Remove four washer head screws (2) in order to remove bracket (4) from valve assembly (1).
Illustration 2 g00576776
Remove four washer head screws (6) in order to remove valve assembly (1) and plate (7) from heater coil assembly (8).
Remove O-ring seal (5) (not shown) from valve assembly (1).
Illustration 3 g00522982
Illustration 4 g00522985
Remove heater coil assembly (8) from air conditioner housing (9). Installation Procedure
Note: Cleanliness is an important factor. Before the installation procedure, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble.
Check all of the O-ring seals and the components for wear or damage. Replace the components, if necessary.
Lubricate all of the O-ring seals with 1U-6396 O-Ring Assembly Compound prior to installation.
Illustration 5 g00522982
Illustration 6 g00522985
Install heater coil assembly (8) into air conditioner housing (9), as shown.
Illustration 7 g00576776
Install O-ring seal (5) (not shown) onto valve assembly (1).
Use four washer head screws (6) in order to install valve assembly (1) and plate (7) onto heater coil assembly (8).
Illustration 8 g00576775
Use four washer head screws (2) in order to install bracket (4) onto valve assembly (1).
Install bolt (3) and the washer. End By:
Install the evaporator coil. Refer to Disassembly and Assembly, "Evaporator Coil - Remove and Install".


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.