TEE 3079637 - Caterpillar

Installation Procedure
Illustration 1 g00839002
Connect electrical connector (18) that is located on the pilot valve.Note: There is one electrical connector on the left pilot valve. There are four electrical connectors on the right pilot valve.
Illustration 2 g00839001
Connect seven hydraulic lines (17) to the pilot valve.
Place console (10) over the pilot valve. Do not install the bolts at this time.
Illustration 3 g00838950
Use three bolts (15) to install pilot valve (16) .
Illustration 4 g00838948
Use two bolts (14) to install cover (13) onto console (10) .
Illustration 5 g00838946
Install two bolts (12) on the side of console (10) .
Illustration 6 g00838945
Install two bolts on the front of console (10) .
Illustration 7 g00839051
Put the plastic separators between the hydraulic lines. Use two bolts (9) to hold clamp (2) together.
Illustration 8 g00839003
Connect any hydraulic lines that were removed from the selector valve that is located beneath the cab.
Illustration 9 g00838944
Connect electrical connector (7) that is located beneath the cab. Install bolt (8) .
Illustration 10 g00838943
Connect hydraulic lines (4) and (5) to shuttle valve (6).
Illustration 11 g00838942
Use two bolts (1) to install clamp (2) into the floor of the cab.
Illustration 12 g00839028
Rotate cover (3) into position. Install the six bolts.