parts catalog

TRACK G.-18 2H9346 - Caterpillar

2H9346 TRACK G.-18 Caterpillar parts TRACK
Alternative (cross code) number:
Caterpillar 2H9346 TRACK G.-18
Weight: 2 pounds 1 kg.

Buy TRACK G.-18 2H9346 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register


Table 1
Required Parts    
Qty     Part Number     Description    
2     3S-2093     Cable Straps    
1     7T-1099     Link    Rework Procedure
Park the machine on level ground and engage the parking brake. Lower the boom until the coupler is at rest on the ground.
Inspect the harness, the connectors and the sensor for signs of damage. Damage to any of these components will possibly cause the unit to malfunction. If the longitudinal stability indicator is malfunctioning and damage is evident to any of these components, replace the components before continuing with this procedure.
Illustration 1 g01263453
The harness (3) will be secured in a loop. Refer to Illustration 1. Cut the cable straps (2) and release the harness (3). Leave the cable straps (1) .
Illustration 2 g01263443
Mark the position for the 7T-1099 Link on the inside of the chassis. Align the 7T-1099 Link with the position of the clip on the rear axle. Refer to Illustration 2.
Illustration 3 g01263436
(A) 15.0 mm (0.59 inch) Minimum (4) 7T-1099 Link
For the TH220B, TH330B, TH340B, TH350B, TH355B, TH360B, TH460B, and TH560B, weld the link to the inside of plate on the chassis side. Refer to Illustration 3. Note: The weld should be 15.0 mm (0.59 inch) from the edge of the plate or any other weld.
Illustration 4 g01263426
For the TH580B, weld the link to the underside of the main plate of the chassis. Refer to Illustration 4.
Illustration 5 g01263418
(4) 7T-1099 Link (5) 3S-2093 Cable Strap
Use the 3S-2093 Cable Strap (5) in order to attach the harness to the 7T-1099 Link (4). Refer to Illustration 5.Note: Adjust the harness in order to avoid any trap points. Adjust the harness in order to allow full oscillation of the axle.Note: If your machine is equipped with frame level, tilt the machine completely to the right. Check that the harness has enough slack. The harness must not tighten.

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.