AVSPARE.COM
parts catalog

TUBE AS 3156646 - Caterpillar



3156646 TUBE AS Caterpillar parts C15, TH35-C15T TUBE
Rating:
57
Alternative (cross code) number:
CA3156646
315-6646
3156646
Caterpillar 3156646 TUBE AS
Weight: 0.20 pounds 0 kg.

Buy TUBE AS 3156646 Caterpillar genuine, new aftermarket tractor parts with delivery
PETROLEUM PACKAGE, TRUCK ENGINE,

Compatible equipment models: 3156646:

PETROLEUM PACKAGE  TH35-C15T  
TRUCK ENGINE  C15   Caterpillar
Number on catalog scheme: 4
 
  For full view, you need register

Information:


Illustration 1 g01007876
Schematic of the circuit of the engine coolant temperature sensorThis diagnostic code is recorded when the ECM reads the signal voltage of the Engine coolant temperature sensor and the voltage is too high. The operating range for the output voltage of the sensor is approximately 0 DCV to 5 DCV.The possible causes of this diagnostic code are listed here:
The sensor has failed.
The return circuit of the sensor is open in the machine harness.
The signal circuit in the machine harness is shorted to a source of positive voltage.
The signal circuit in the machine harness is open or the sensor is disconnected.
The ECM has failed. This is unlikely. System Response:The diagnostic code of CID 0110 FMI 03 will be logged in the internal memory of the ECM. When the diagnostic code occurs, the following responses will occur.
The action alarm will sound.
The engine coolant gauge will display the maximum temperature.Test Step 1. CHECK THE CONTROL AND THE HARNESS.
Turn the disconnect switch and the key start switch to the ON position.
Disconnect the machine harness connector from the engine coolant temperature sensor.
At the machine harness connector for the sensor, measure the voltage (DCV) between the signal contact 1 (wire 441-OR) and the return contact 2 (wire J764-BR). Expected Result:The voltage is between 0 and 5 DCV.Results:
OK - The voltage is between 0 and 5 DCV. The ECM and the harness are correct. Repair: Replace the sensor. Stop.
NOT OK - The voltage is not between 0 and 5 DCV. The ECM may have failed or the harness has failed. Proceed to Test Step 2.Test Step 2. CHECK THE RETURN CIRCUIT OF THE HARNESS.
The sensor remains disconnected.
Turn the disconnect switch (if equipped) and the key start switch to the OFF position.
Disconnect the J1 and J2 machine harness connectors from the ECM.
Measure the resistance of the return circuit between contact 2 (wire J764-BR) of the machine harness for the sensor and contact J1-45 of the machine harness for the ECM. Expected Result:The resistance is less than 5 ohms. Results:
OK - The resistance is less than 5 ohms. The harness resistance is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 ohms. The ground circuit in the harness has failed. There is an open circuit between the ground contact and frame ground. Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK FOR A SHORTED HARNESS
The sensor and the ECM remain disconnected from the machine harness.
The disconnect switch and the key start switch remain in the OFF position.
At the machine harness connector for the sensor, measure the resistance between the signal contact 1 (wire 441-OR) and all contacts that are used in the machine harness connector for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The ECM has failed.Repair: It is unlikely that an ECM has failed. Exit this procedure. Perform this diagnostic code procedure again. If the failure is not found, replace the

Caterpillar parts catalog:

Caterpillar parts catalog
C15 On-highway Engine SDP00001-UP
C15 ON-HIGHWAY ENGINE B5R00001-UP
TH35-C15T Petroleum Package PBL00001-UP POWERED BY TH35-C15T PETROLEUM


Parts tube Caterpillar catalog:

2644289 TUBE-OIL FILLER
3116, 3126, 3126B, 3126E, 3176, 3406E, 75C, 815B, 85C, C-10, C-12, C-15, C-16, C11, C13, C15, C7, C9, CX31-C13I, CX31-C9I, TH31-E61, TH35-C11I, TH35-C13I, TH35-C15T
1152359 TUBE AS
3406B, 3406C, 3406E, 3456, 770, 770G, 770G OEM, 824C, 824G, 824G II, 824H, 824K, 825G II, 825H, 825K, 826G II, 826H, 826K, 980G, 980G II, 980H, 986H, AD55, C-15, C-16, C-18, C15, C16, C18, CX31-C15I, ...
4S8603 TUBE AS-SCREEN
14G, 16G, 24H, 3192, 515, 525, 525B, 611, 613C, 613C II, 613G, 615, 615C, 65, 69D, 7211, 7231, 7241, 7251, 7261, 7271, 769C, 769D, 771C, 771D, 773B, 773D, 773E, 773F, 775B, 775D, 775E, 775F, 776, 777,...
2764637 TUBE AS-OIL JET
365C, 365C L, 365C L MH, 374D L, 374F L, 583T, 587T, 621B, 621G, 623G, 627F, 627G, 631D, 637D, 651B, 657E, 657G, 735, 735B, 740, 740B, 770, 770G, 770G OEM, 824C, 824H, 824K, 825H, 825K, 826H, 826K, 98...
2919948 TUBE AS
C15, TH35-C15T
2955510 TUBE AS
C15, TH35-C15T
3280851 TUBE AS
C15, TH35-C15T
2906554 TUBE AS
C15, TH35-C15T
2850202 TUBE AS
C15, TH35-C15T
2893993 TUBE AS
C15, TH35-C15T
3003386 TUBE AS
C15, TH35-C15T
3003385 TUBE AS
C15, TH35-C15T
2899290 TUBE AS
C15, TH35-C15T
2899289 TUBE AS
C15, TH35-C15T
2825391 TUBE AS
C15, TH35-C15T
2824963 TUBE AS
C15, TH35-C15T
2719078 TUBE AS
C15, TH35-C15T
3082110 TUBE AS
C15, TH35-C15T
3018004 TUBE AS
C15, TH35-C15T
3016077 TUBE AS
C15, TH35-C15T
3016076 TUBE AS
C15, TH35-C15T
3016075 TUBE AS
C15, TH35-C15T
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.