AVSPARE.COM
parts catalog

TUBE, HCI COOLANT SUPPLY 7096543C1 - Caterpillar



7096543C1 TUBE, HCI COOLANT SUPPLY Caterpillar parts TUBE
Rating:
61
Alternative (cross code) number:
CA7096543C1
70965-43C1
7096543C1
Caterpillar 7096543C1 TUBE, HCI COOLANT SUPPLY

Buy TUBE, HCI COOLANT SUPPLY 7096543C1 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 1
 
  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
ZZ     6V-9507     Face Seal Plug     2    
6V-9512 Face Seal Plug     2    
6V-9828 Cap As     2    
6V-9833 Cap As     2    Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Mark the location of all hose assemblies and fittings for assembly purpose.
Drain the hydraulic system oil into a suitable container for storage or for disposal. The capacity of the hydraulic system is approximately 300 L (79 US gal). Refer to Operation and Maintenance Manual, "Capacities (Refill)". Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the correct procedure.
Open the rear grill assembly.
Illustration 1 g00928675
Disconnect harness assembly (7) .
Disconnect hose assemblies (1) and (2) .
Disconnect tube assemblies (3) and (4) .
Remove bolts (5) and remove valve (6) .Installation Procedure
Illustration 2 g00928675
Position valve (6) and install bolts (5) .
Connect tube assemblies (3) and (4) .
Connect hose assemblies (1) and (2) .
Connect harness assembly (7) .
Close the rear grill assembly.
Fill the hydraulic system with oil. The capacity of the hydraulic system is approximately 300 L (79 US gal). Refer to Operation and Maintenance Manual, "Capacities (Refill)". Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the correct procedure.

Caterpillar parts catalog:



Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.