AVSPARE.COM
parts catalog

TUBE A. 7B0164 - Caterpillar



7B0164 TUBE A. Caterpillar parts TUBE
Rating:
51
Alternative (cross code) number:
CA7B0164
7B-0164
7B0164
Caterpillar 7B0164 TUBE A.

Buy TUBE A. 7B0164 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 459-4664 Valve Spring Compressor 1 Start By:
Remove the electronic unit injector. Refer to Disassembly and Assembly, "Electronic Unit Injector - Remove".
Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01206603
Illustration 2 g01207146
Install Tooling (A) into the hole for the electronic unit injector. Refer to Illustration 2. Refer to the Tool Operating Manual, NEHS1205.
Illustration 3 g01851274
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install the plate of Tooling (A) onto the valve springs. Refer to Illustration 3. Install the nut onto the stud. Tighten the nut to compress valve springs (2). Remove retainer locks (1).
Illustration 4 g01206605
Remove Tooling (A). Remove rotocoil (3), outer spring (4), inner spring (5), valve seal (6), retainer (7), and valve (8).Installation Procedure
Illustration 5 g01206605
Install valve (8), retainer (7), valve seal (6), inner spring (5), outer spring (4), and rotocoil (3).
Illustration 6 g01206603
Illustration 7 g01228542
Illustration 8 g01851274
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Use Tooling (A) to compress valve springs (2). Install retainer locks (1). Release the tension on valve springs (2). Remove Tooling (A). Install a screwdriver into the hole for the injector. Slowly rotate the engine until the piston is approximately 25 mm (1.00 inch) below top dead center. Lightly strike the tops of the valves with a soft faced hammer to ensure that retainer locks (1) are properly seated.End By:
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".
Install the electronic unit injector. Refer to Disassembly and Assembly, "Electronic Unit Injector - Install".


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.