AVSPARE.COM
parts catalog

VALVE 1C4281 - Caterpillar



1C4281 VALVE Caterpillar parts VALVE
Rating:
16
Alternative (cross code) number:
CA1C4281
1C-4281
1C4281
Caterpillar 1C4281 VALVE
Weight: 10 pounds 4 kg.

Buy VALVE 1C4281 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Start By: a. remove drive shaft (power shift)b. remove axles1. Drain the oil from the transmission and bevel gear case. 2. Remove the bolts and grab iron (1) from the rear of the fuel tank. 3. Remove bolt (4). Remove the clip and hose (5) from the fuel tank.4. Remove bolts (3), cover (2) and the gasket from the rear of the transmission. 5. Remove the bolts, cover (7) and the gasket from the rear of the transmission.6. Remove bolts (6), and disconnect the control linkage from the hydraulic control valve. 7. Install Tooling (A) on the rear of the transmission as shown. Fasten a hoist to Tooling (A).8. Remove the bolts that hold transmission and bevel gear (8) to the main frame case. Pull the transmission and bevel gear out of the main frame case until rollers (9) are at the end of the rail assemblies as shown. 9. Put a two ton floor jack (10) or wooden blocks in position under the rear of the transmission to support it when the hoist is removed.10. Remove the hoist from Tooling (A). Fasten the hoist and Tooling (B) to the transmission and bevel gear as shown. Remove the transmission and bevel gear from the machine. The weight of the transmission and bevel gear is 424 kg (935 lb).11. Remove the O-ring seal from the transmission and bevel gear.12. Remove the three O-ring seals from the rear of main frame case.Install Transmission & Bevel Gear (Power Shift)
1. Put the O-ring seals in position on the main frame case and on the transmission and bevel gear. 2. Fasten a hoist and Tool (A) to transmission and bevel gear (1).3. Put the transmission and bevel gear in position in the main frame case. Make sure rollers (3) are against the stops on rails (4) as shown.4. Put a two ton floor jack (2) or wooden blocks in position under the rear of the transmission to support the transmission and bevel gear when the hoist is removed.5. Remove the hoist and Tool (A).6. Install Tooling (B) on the rear of the transmission as shown. Fasten the hoist to Tooling (B). 7. Support the weight of the transmission with Tool (A) and the hoist, and remove the floor jack.8. Use the hoist and Tool (A), and install the transmission and bevel gear in the main frame case. Install bolts (5) that hold the transmission and bevel gear in place.9. Remove the hoist and Tooling (B). 10. Put the control linkage in position on the hydraulic control valve, and install two bolts (6).11. Put the gasket and cover (7) in position on the rear of the


Parts valve Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.