AVSPARE.COM
parts catalog

VALVE GP- 4645053 - Caterpillar



4645053 VALVE GP- Caterpillar parts VALVE
Rating:
26
Alternative (cross code) number:
CA4645053
464-5053
4645053
Caterpillar 4645053 VALVE GP-

Buy VALVE GP- 4645053 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:
 
  For full view, you need register

Information:


Illustration 1 g01309755
Schematic of the CAN A Data Link circuitThis diagnostic code is recorded when the Machine ECM does not receive expected information from the key reader module over the data link.Test Step 1. CHECK THE ET DIAGNOSTIC SCREEN.
Check the ET diagnostic screen for a communication error between the machine ECM and the Key Reader Module.Note: The key reader communication diagnostic code is CID 1960 FMI 09.Expected Result:The ET reports CID 1960 FMI 09 as active or the diagnostic code has been logged.Results:
YES - The ET reports CID 1960 FMI 09 as active or the diagnostic code has been logged.Repair: Troubleshoot the CAN data link connections between the key reader module and the machine ECM. Proceed to Test Step 3.
NO - The diagnostic code has NOT been logged or the diagnostic is NOT active. Proceed to Test Step 2.Test Step 2. CHECK FOR POWER TO THE KEY READER MODULE.
The key reader module remains connected to the machine harness.
Turn the key switch to the ON position.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the voltage supply (wire 308-YL) for contact 1.
At the back of the harness connector for the sensor, insert the other 7X-1710 Multimeter Probe along the ground (wire 200-BK) for contact 2.
Measure the voltage.Expected Result:The voltage that is measured is approximately system voltage.Results:
YES - The voltage that is measured is approximately system voltage. The voltage is correct. Proceed to Test Step 4.
NO - System voltage is NOT present. The wiring harness has failed.Repair: Check the wiring harness for signs of damage. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK THE CAN DATA LINK WIRING OF THE MACHINE HARNESS FOR AN OPEN CIRCUIT.
Disconnect the J2 harness connector from the machine ECM.
On the key reader side of the harness, install a jumper wire between pin 3 and pin 4.
At the J2 of the machine ECM, measure the resistance between pin 67 and pin 68 of the connector for the machine ECM.Expected Result:The resistance is greater than 5000 ohms.Results:
YES - The resistance is greater than 5000 ohms between pin 3 and pin 4. The wiring for the CAN link, between the ECM and the key reader module is NOT correct.Repair: Check the wiring harness for signs of damage. Repair the machine harness or replace the machine harness.STOP
NO - The

Caterpillar SIS machinery equipment:

Caterpillar SIS


Parts valve Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.