AVSPARE.COM
parts catalog

WASHER 0005620 - Caterpillar



0005620 WASHER Caterpillar parts WASHER
Rating:
86
Alternative (cross code) number:
CA0005620
000-5620
0005620
Caterpillar 0005620 WASHER

Buy WASHER 0005620 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
Allied Titanium 0005620, (Pack of 5) #10-32 X 1/4 inch UNF Titanium Set Screw, Socket Drive with Cup Point, Grade 5 (Ti-6Al-4V)
$28.35

01 Oct 2021
0.0037[0.00] Pounds
US: Allied Titanium
Allied Titanium 0005620, (Pack of 5) #10-32 X 1/4 inch UNF Titanium Set Screw, Socket Drive with Cup Point, Grade 5 (Ti-6Al-4V)
Allied Titanium #10-32 X 1/4 inch UNF Allied Titanium Set Screw, Socket Drive with Cup Point || TRUE TITANIUM(TM) - Stronger, Lighter and Corrosion Free || Titanium is good for use in or near saltwater || General Tolerance: +/- 0.007 inch || Meets ASME B18.3; Grade 5 (Ti-6Al-4V) Titanium with Polished Finish
  For full view, you need register

Information:

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-7505 Hydraulic Jack 1 Note: Check the O-ring seals for wear or for damage. Replace the O-ring seals, if necessary.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00853136
Illustration 2 g00853105
Hydraulic block (2) is bolted to the inside of the main frame just below the starting motor.
Install hydraulic block (2) on the inside of the main frame with bolts (7).
Install hose assembly (9) and tube assembly (8).
Install swivel tee (4) to hydraulic block (2). Install bolt (10) that secures the clip for tube assemblies (8) and (6) to the inside of the main frame.
Install hose assemblies (5) and (3).
Illustration 3 g01051123
Install engine side guard (1A) on the right side of the machine.
Illustration 4 g00853562
Use Tooling (A) in order to position middle bottom guard (1) for installation. The weight of middle bottom guard (1) is approximately 35 kg (77 lb). Install the bolts for the middle bottom guard. Remove Tooling (A).
Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraualic System Oil - Change" and Operation and Maintenance Manual, "Capacities (Refill)".


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.