AVSPARE.COM
parts catalog

WASHER 3156511 - Caterpillar



3156511 WASHER Caterpillar parts 303.5C, 304D CR, 305C CR WASHER
Rating:
46
Alternative (cross code) number:
CA3156511
315-6511
3156511
Caterpillar 3156511 WASHER

Buy WASHER 3156511 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

Compatible equipment models: 3156511:

MINI HYD EXCAVATOR  303.5C   304D CR   305C CR   Caterpillar
Number on catalog scheme: 20
  
  For full view, you need register

Information:


Illustration 1 g01375179
Schematic of the left front drive motor solenoidThis diagnostic code is associated with the left front drive motor solenoid solenoid (all wheel drive). The FMI 03 means that the ECM has determined that the voltage of the solenoid circuit is above normal. The possible causes of the diagnostic code are listed:
The energize circuit of the solenoid is shorted to the +Battery circuit.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 2293 FMI 03 is active before performing this procedure.Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).System Response:The diagnostic code CID 2293 FMI 03 will be logged in the internal memory of the ECM of the All Wheel Drive (AWD).The AWD feature will be disabled.Test Step 1. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness connector from the solenoid. Disconnect the machine harness connectors J1 and J2 from the AWD Controller.
At the ECM connector J1 of the machine harness, measure the resistance from contact J1-58 (wire 845-OR) to all J1 and J2 contacts that are used on the AWD ECM.Expected Result:Each resistance measurement is greater than 5000 ohms. Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 2.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the machine harness. The short is between wire 845-OR and the circuit that has a low resistance measurement. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE OPERATION OF THE ECMThe disconnect switch and the key start switch remain in the OFF position. The machine harness connectors for the solenoid and the ECM remain disconnected.
At the ECM connector J1 of the machine harness, use a 151-6320 Removal Tool to remove the wire 845-OR and the socket at contact J1-58 from the harness connector.
Reconnect the machine harness J1 and J2 connectors to the ECM.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the active CID 2293 FMI 03 diagnostic code.Expected Result:The CID 2293 FMI 03 diagnostic code is no longer active. A CID 2293 FMI 05 diagnostic code is now active.Results:
YES - The CID 2293 FMI 03 diagnostic code is no longer active. A CID 2293 FMI 05 diagnostic code was activated after the energize circuit of the solenoid was disconnected. The ECM has responded correctly to the open circuit condition in the solenoid circuit.
Reconnect the energize circuit of the solenoid wire back into the correct space in the ECM connector.
Proceed to Test Step 3.
NO - The CID 2293 FMI 03 diagnostic code remains active. The status of the active diagnostic code did not

Caterpillar parts catalog:

Caterpillar parts catalog
304D CR Mini Excavator TYK00001-UP (MACHINE) POWERED BY S3Q2 Engine
303.5C CR Mini Hydraulic Excavator DMY00001-UP (MACHINE) POWERED BY S3Q2 Engine
303C CR Mini Hydraulic Excavator BXT00001-UP (MACHINE) POWERED BY S3Q2 Engine
305 C CR Mini Hydraulic Excavator HWJ00001-UP (MACHINE) POWERED BY S4Q2T Engine


Parts washer Caterpillar catalog:

3154539 WASHER
303.5C, 303.5D, 304C CR, 304D CR, 305C CR, 305D CR
1183814 WASHER
303.5C, 304D CR, 305C CR, 315B, 933, 933C, D3C III, D4C III, D5C III
1369519 WASHER-COATED
303.5C, 304C CR, 304D CR, 305C CR, 315B, 933, 933C, 939C, D3C III, D3G, D4C III, D4G, D5C III, D5G
1184805 WASHER
303.5C, 304C CR, 304D CR, 305C CR, 315B, 933, 933C, D3C III, D4C III, D5C III
2706251 WASHER
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR, 904B, 904H
2230279 WASHER
301.6C, 303.5C, 304D CR, 305.5D, 305C CR, 904H
2962616 WASHER
303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E
2812955 WASHER
303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E
2664024 WASHER-SPRING
303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E
2664078 WASHER-THRUST
303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304D CR, 304E
3154546 WASHER
303.5C, 303.5D, 304C CR, 304D CR, 305C CR, 305D CR
2828618 WASHER-SPRING
303.5C, 303.5D, 303C CR, 304C CR, 304D CR, 305.5D, 305C CR, 305D CR
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.