parts catalog

WHEEL & TIRE AS 5088652 - Caterpillar

5088652 WHEEL & TIRE AS Caterpillar parts WHEEL
Alternative (cross code) number:
Caterpillar 5088652 WHEEL & TIRE AS

Buy WHEEL & TIRE AS 5088652 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 3
  For full view, you need register


Failure to properly service the batteries may cause peronal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (−) to battery negative (−).Jump start only with an energy source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
When starting from another machine, make sure that the machines do not touch. This can prevent damage to engine bearings and electrical circuits.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.This machine has a 24 volt starting system. Use only the same voltage for jump starting. Use of a higher voltage damages the electrical system.
Use of Jump Start Cables
When the auxiliary starting receptacles are not available, use the following procedure.
Determine the reason that the engine will not crank. Refer to Special Instruction, REHS0354, "Charging System Troubleshooting". The procedure is applicable even if the machine does not have a diagnostic connector.
On the stalled machine, place the transmission direction control in the NEUTRAL position. Engage the parking brake. Lower all attachments to the ground. Move all controls to the HOLD position.
Turn the engine start switch key to OFF on the stalled machine. Turn off all accessories.
Turn on the battery disconnect switch on a stalled machine.
Move the boost machine so that the cables can reach the stalled machine. DO NOT ALLOW THE MACHINES TO CONTACT EACH OTHER.
Stop the engine on the boost machine. If you are using an auxiliary power source, turn off the charging system.
Check the battery caps for correct placement and for correct tightness. Make these checks on both machines. Make sure that the batteries in the stalled machine are not frozen.
Connect the positive jump-start cable to the positive cable terminal of the discharged battery. Do not allow positive cable clamps to contact any metal except for battery terminals.Note: Batteries in series may be in separate compartments. Use the terminal that is connected to the starter solenoid. This battery is normally on the same side of the machine as the starter.
Connect the positive jump-start cable to the positive terminal of the boost source. Use the procedure from Step 8 in order to determine the correct terminal.
Connect one end of the negative jump-start cable to the negative terminal of the electrical source.
Make sure that

Caterpillar parts catalog:

Caterpillar parts catalog
424B2 Backhoe Loader Side Shift JTH00001-UP (MACHINE)
424B Backhoe Loader Side Shift JRN00001-UP (MACHINE)
424B HD Backhoe Loader JRY00001-UP (MACHINE)

Parts wheel Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.