AVSPARE.COM
parts catalog

WRENCH- 2278209 - Caterpillar



2278209 WRENCH- Caterpillar parts WRENCH
Rating:
71
Alternative (cross code) number:
CA2278209
227-8209
2278209
Caterpillar 2278209 WRENCH-
Weight: 0.010 pounds 0 kg.

Buy WRENCH- 2278209 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

You must read and understand the warnings and instructions contained in the Safety section of this manual before performing any operation or maintenance procedures.Cooling System Coolant
Change Coolant/Clean System
Do not change the coolant until you read and understand the material in the Cooling System Specifications section.
Drain the coolant earlier whenever the coolant is dirty or foaming is observed. The radiator cap is located at the left rear of the machine. 1. Remove the radiator cap slowly to relieve pressure. 2. Open the drain valve and allow the coolant to drain. Drain valve is located under the radiator.3. Close the drain valve. Fill the system with clean water and a 6 to 10% concentration of cooling system cleaner.4. Start and run the engine for 90 minutes. Stop the engine and drain the cleaning solution.5. Flush the system with water, with the engine stopped, until the draining water is clear.6. Close the drain valve.7. Add the coolant solution. See Cooling System Specifications and Lubricant Viscosities and Refill Capacities. Do not add supplemental coolant additive or change element at this time, unless you are not using Caterpillar Antifreeze which contains additive.8. Start the engine and operate it with the radiator cap off, until the thermostat opens and the level stabilizes.9. Maintain the coolant level to within 13 mm (.5 in) of the bottom of the fill pipe.10. Install the cap.11. Stop the engine.Clean the Cooling System Relief Valve
Clean or replace the relief valve if the system overheats or loss of coolant is observed.1. Remove radiator cap (1) slowly to relieve pressure.2. Remove bolts (2) from the valve and remove the valve assembly. 3. Inspect valve (5), valve seals (4) and gasket (3). Replace if necessary.4. Inspect valve cover (6) and mounting bolts (2).5. Install the relief valve assembly.6. Check the coolant level. Maintain the coolant level to within 13 mm (.5 in) of the bottom of the fill pipe.7. Install the radiator cap.Clean Outside of Radiator Fins
Compressed air is preferred, but high pressure water or steam can be used to remove dust, leaves and general debris from radiator fins.


Parts wrench Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.